0
The sensors all work together and the computer tells it when to shift.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Harsh 1-2 shift on cold 4l60e trans?
bad catalytic converter
99 Chrysler 300 having trans problem it shows there is ratio codes in both 2 and 1 and it also a code for fault immeditaly after shift.?
You need to have it driven with a scan tool while watching the speed sensors. Either an input or output speed sensor can cause that.
Where is the shift solenoid on a 1998 dodge caravan?
It is part of the 6 in by 2 in by 4 in tall "brick" on the front of the trans.
Where is the o2 sensor located on a 1997 Isuzu rodeo?
the o2 sensors are located on the exhaust pipe one by trans and one by the muffler there is 2 of them
What is the gas tank capacity of a 1996 Toyota Tercel 2 dr automatic trans?
it tells you in the manual. I have a '96 tercel 2 door manual trans. and I do believe the gas tank capacity is 47 litres.
What would cause a 1998 Chevy truck to shift roughly from 1 to 2 gear?
Sounds like the transmission is in the fell safe mode. That is a safety mode that the transmission goes into to keep the transmission line pressure from blowing the trans. apart when there is an internal problem in the transmission. You will always get a hard shift from 1--2 shift. when this happens. You can save your trans. if you stop driving it now, and get it to a transmission shop. Your check engine light should be on are coming on and off.
Why won't a GM 4L80E transmission shift in forward gears?
check the wires to the speed sensor at the trans at under the dash. if 1 is unhooked the speedometer will not work and it will only shift from 1'st to 2'nd if you manualy shift it, but it will not go any higher than 2'nd. this is a safety feature to prevent odometer tampering.
What is input and output speed sensors?
these are sensors on the outside case of the transmission - on the left side/ drivers side 1 is above the CV halfshaft (axle ) the other is about 5" behind it -- each sensor has 2 wires going into it -- the negative and positive. these things are made of plastic and are easily removed with a socket. They also control the shift points -- they make the transmission shift.
How many O2 sensors in a 2008 jeep grand Cherokee overland 5.7L hemi?
there are 2 sensors #2 and 2 sensors #1
Where is the 2-3 shift solenoid located on a ford ranger 4speed auto transmission2000ford ranger location of transmission 2-3 shift solenoid?
I could be wrong but what it sounds like to me is what is called the servo covers located just above the trans pan on the right hand side
Your dodge stratus went in to low gear and RPM gauge stopped and automatic gear shift stuck in low gear not shifting?
I would definitely check to see if your speed sensors are working correctly. If you own a 99 like I do, you should have 2, an input and an output. If one or both of those speed sensors stop working then the RPM gague stops working and the car will not shift.
Your 1989 190e 2.6 auto trans will not shift into 4th gear if you shift it by hand ie 2nd 3th d you get 2 shifts if you stay in d you also get 2 shifts rpm's are 2600 at 55mph whats your problem?
MB's take off in 2nd to save gas is what i was told.
