If you are refering to a wall receptacle, the one on the right is the hot side. The left side is the neutral and it's slot is larger that the hot one. The U shaped on the bottom is for the ground pin of the plug.
Answer for USA, Canada and countries running a 60 Hz supply service.
On a plug (cap) wire end, the "hot" blade is the smaller of the two. On a receptacle in the wall the smaller blade is also the "hot" connection. Both connection terminals will be using a brass coloured screw to identify the position to place the "hot" wire.
You can never tell unless you use a tester. If everything is wired correctly it should always be the smallest prong.
On a 240 volt outlet, such as a dryer outlet: G is Ground, W is Neutral, X and Y are the two Hot legs.
On a 3 wire plug (NEMA 5 configuration, 125v 2 pole 3 wire grounding) the narrow blade is the "hot" lead, the wide blade is the neutral lead, and the U shaped prong is the equipment grounding conductor (EGC). Most 2+G non-metallic-cables (NMC) are color coded for Black = "hot", White = neutral, and Bare = EGC
A NEMA 5-20 plug is a standard 3 prong plug. It wires the same as a NEMA 5-15 plug (Ground wire to the "D" contact, Hot to vertical terminal and neutral to the horizontal terminal (with the Ground terminal either at the top or bottom)).A 5-20P plug has the neutral blade rotated 90°. The 5-20R receptacle usually has a T-shaped neutral hole, to accept both 5-15P and 5-20P plugs.
In the US the larger prong is Nuetral and the smaller is Live or Positive.
On a 240 volt outlet, such as a dryer outlet: G is Ground, W is Neutral, X and Y are the two Hot legs.
No, the wide prong is neutral it is the white wire. The narrow prong is hot it is the black wire. The round prong (in a 3 wire plug) is safety ground it is the green wire.
On a three prong plug there will be a neutral blade, a "hot" blade and a ground blade. The neutral blade is wider that the "hot" blade. In North America the ground blade is "U" shaped.
A polarized plug can only fit together in one direction. This is to prevent reverse polarity in the device you are plugging in.
No you can not you will need to replace the plug with a 4 prong the same as the style of your oven and change your breaker to the correct Amp for your style of 4 prong plug
Ground wire
My question is WHY did you replace a four prong dryer plug with a three prong! 220 volt Electric dryers require two hot legs, a neutral and a system ground wire. Sounds as though you shunted one of the hots or the neutral. You need to install a four prong plug of the same configuration and wire it exactly as the original.
Not in itself. Do not plug another three prong plug in the outlet until the broken prong (round-ish) is removed from the outlet. The third prong (round-ish) on a three prong plug is the ground. It does not carry any power.Correction"It's the power return"
Need to know the amperage rating of the plug or the NEMA configuration of the plug and receptacle
I,m going to bypass the generator and plug into the house for my race car trailor. Once I pull the plug from the gewnerator I will have a four prong male need to plug into a for prong female then be able to plug into a house socket.
The 3rd round plug is the ground connection.
This is a 2 prong polarized female. However a 2 prong unpolarized male will easily plug into a 2 prong polarized female. just not the other way around.
NO IT CAN NOT BE REPLACED THERE IS INTERNAL ELECTONIC DIFFERENCES.