Want this question answered?
You cannot control your Sony Receiver with your Sharp TV remote. Sharp remotes can control many brands of DVD and Blu-Ray players, but only Sharp receivers. You should program your Sony receiver's remote to control your TV instead. How you do this is outlined in your owners' manual.
Hold the button you want to program and then hold the on/off button at the same time it should program
To program a GPT universal remote control, hold down the power button at the same time with the button for the device that is going to be programmed. When the other buttons on the remote blink, let up and press on the power button again. The device should turn on. If not, repeat the process.
You can program your DISH remote to work on other electronic equipment. The gyration remote should have instructions on how to program it to other components. If you don't have the instructions, I would give the company a call to try and get the instructions.
A few different DISH Network remote codes for your iLO TV that you can try & one should successfully program your remote are, 569, or 720.
If you have direct tv, you can just go to the menu and look for the code for the specific TV. And if you find the code, you have to know how to program that certain remote control. And if not just go to a Electronics store and buy a ten dollar remote and get the codes off of the instructions. They should definitely have the codes.
What you can do is get a universal remote control and program it with it. It should cost 30 dollars or less. The controls you can program them with a DVD-VCR radio and a lot more so you should be fine.
Here are a few different DISH Network remote codes for your Insignia TV that you can try & one should successfully program your remote are, 720, 566, or 538.
To program the Digital Prism 8-in-1 Universal Remote Control, on must acquire the programming codes for the devices to program. These can be found in the manual for the remote or on the manufacturer's website. Then one follows the directions in the manual as to the order to input the codes.
In the instructions it should say how to program it to your own garage door. Much like a universal remote control for your television.
A few different DISH Network remote codes for your Durabrand TV that you can try & one should successfully program your remote is 220 (this is the most successful code,) 720 or 015.
Check your owners manual for a directions on programming your remote. You should find a step by step guide on how to program it.