The neutral wire and power wire are never connected together.
Power into the first outlet and out to all other outlets, black to gold and white to silver screw, ground wires to ground screw. From the outlet closest to the light switch run power from that outlet up to the switch box. Run another wire from the switch box up to the light. In the switch box tie all the whites together under a wire nut and push them back into the box. Tie all the ground wires together and connect that to the ground screw on the switch. Connect the 2 black wires you have left to the 2 screws on the switch. Does not matter which if you only have power in and power out to the light.
Black is the hot side of the line, white the neutral side, green (or rarely bare) wire is the ground.
Connect all white wires together under a wire nut and push them back into the box. Connect all ground wires together and then connect them with a jumper wire to the ground screw on the switch. Connect black power in and power out, if applicable, wires to the bottom screw on the switch. Connect the remaining black wire going to the light to the top screw on the switch.
In most home wiring circuits, the black wire is used to power a light bulb. The other wire is white and is called the neutral conductor.
White is neutral in home wiring. Red is sometimes used in 3-way switches and dimmer applications, so it is likely red is hot in your application if it pertains to home wiring. The term positive would just apply to DC wiring since AC goes positive and negative. For example your car battery has Red as Positive and Black as Negative.
the motor should have two leads, usually a black and a white. connect the white to the fusebox and the black to a ground.
Yes. Connect Black to Black, White to White and bare ground wires together.
Yes, the ribbed side is neutral (white), the opposite side is hot (black) and the center is ground.
on your car the white w/blue stripe is 12 volt power you connect it to the yellow on the jvc stereo and the yellow w/ red stripe is the 12 volt accessory connect it to the red on the jvc stereo and connect the jvc stereo ground (black) to your cars black wire on the harness
Power into the first outlet and out to all other outlets, black to gold and white to silver screw, ground wires to ground screw. From the outlet closest to the light switch run power from that outlet up to the switch box. Run another wire from the switch box up to the light. In the switch box tie all the whites together under a wire nut and push them back into the box. Tie all the ground wires together and connect that to the ground screw on the switch. Connect the 2 black wires you have left to the 2 screws on the switch. Does not matter which if you only have power in and power out to the light.
In common house wiring, black is the power wire, white is the neutral, and green is the ground wire.
Black Wire from photocel to hot wire(black) coming in red wire to light fixtures black wire. White wire to neutral wires all light and power source white.
You switched the power and switch wires. There should be two sets of wires in the ceiling box. 2 black, 2 white, 2 bare. Two groups of three. The white wire going to the light is the incoming wire. The black one in that group is the power coming in. Take that black wire and connect it to the other black wire. The second black wire goes to the switch. The power comes back to the light on the white wire of that set. Connect that white wire to the black wire in the fixture. The switch should work now. That is if everyone wired the house the way it is supposed to be.
Shield is ground. White is Neutral, center tap of the transformer from the power company.
Black is hot, white is neutral, but it sounds like they may be reversed. Turn the power off at the breaker first.
Black is the hot side of the line, white the neutral side, green (or rarely bare) wire is the ground.
More information is needed as to what device you are connecting to what power supply. The only two identifiable wires are the white and green. In North America the white colour is used for the circuit's neutral and the green is used for grounding of devices.