Convergence
Route advertisement.
A router is a device that routes all traffic to and from your network. A router functions by forwarding packets of data between computer networks.
to config a router manually
The router will be unable to ping 192.168.1.2. The router has two interfaces that participate in the RIP process. The router will forward the updates for 192.168.1.0 on interface Serial0/0/1. The router is not originating routes for 172.16.1.0.
This is when network routes are manually entered into a router's configuration, as opposed to using a routing protocol to automatically determine routes.
This is when network routes are manually entered into a router's configuration, as opposed to using a routing protocol to automatically determine routes.
The router will assume it has knowledge of all subnets in the network and will not search beyond child routes for a better match.
The router will install both routes in the routing table and load balance between the two.
Router is a Layer 3 (Network Layer)device that checks packet's IP Address at input interface & routes them to interface connected to destination network if available.
In networking there is a source and a destination and when both of them communicates there is transfer of packets. There are many routes that can be taken to deliever packet from source to destination but out of all the routes the best route is to be selected, which is done by router and this process is called as routing.
contain tables of ip addresses along with optional routes to other networks. answerd by tyler brewer
you display any active routes within the network