The router will assume it has knowledge of all subnets in the network and will not search beyond child routes for a better match.
if a protocol is only classfull(RIPv1, IGRP) the command will have no effect, but in protocols that support vlsm and classless ip adressing it will enable the protocol to send the subnet mask in it's packets so that a router would not recognize only class networks, but also their subnets.
the router is assigned an ip address.
Your Router is assigned an IP address that is known as a public IP address then your router assigns out IP addresses that are known as local IP addresses. So the answer is yes and yes!
One can reset the IP address with a Linksys router very easily. One must first reset the router, then go into the computer networking settings and reset within the settings.
CDP Cisco Discovery protocol identifies the IP addresss of neighbor router in a corporate network.
The command ip classless is enabled on the router.
if a protocol is only classfull(RIPv1, IGRP) the command will have no effect, but in protocols that support vlsm and classless ip adressing it will enable the protocol to send the subnet mask in it's packets so that a router would not recognize only class networks, but also their subnets.
the router is assigned an ip address.
A router that is set up to route IP packets.
ip classless
Your Router is assigned an IP address that is known as a public IP address then your router assigns out IP addresses that are known as local IP addresses. So the answer is yes and yes!
TCP/IP protocols are implemented by software, except for the bottom physical layer, which is implemented in hardware.
Direct and Indirect DeliveryForwarded IP packets use at least one of two types of delivery based on whether the IP packet is forwarded to the final destination or whether it is forwarded to an IP router. These two types of delivery are known as direct and indirect delivery.Direct delivery occurs when the IP node (either the sending node or an IP router) forwards a packet to the final destination on a directly attached network. The IP node encapsulates the IP datagram in a frame format for the Network Interface layer (such as Ethernet or Token Ring) addressed to the destination's physical address.Indirect delivery occurs when the IP node (either the sending node or an IP router) forwards a packet to an intermediate node (an IP router) because the final destination is not on a directly attached network. The IP node encapsulates the IP datagram in a frame format, addressed to the IP router's physical address, for the Network Interface layer (such as Ethernet or Token Ring).IP routing is a combination of direct and indirect deliveries.In Figure 1.14, when sending packets to node B, node A performs a direct delivery. When sending packets to node C, node A performs an indirect delivery to Router 1. Router 1 performs an indirect delivery to Router 2. Router 2 performs a direct delivery to node C.
The Router only has one M.A.C Address and One IP Address But, the Router can have many Connections ( Devices using the network ) That may shoe up as their IP Addresses. But the Router only Has One IP Address
If you have changed DHCP ip range, the ip address for your router has changed too. You can find your router ip address in your wireless adapter information.
broadcast the packet through all interfaces except the one on which it was received
On a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routing