answersLogoWhite

0

What else can I help you with?

Related Questions

What two areas were not directly connected by land-based trade route?

Europe and Egypt


According to the map which two areas were not directly connected by a land-based trade route?

We don't have the map you are using for your homework so can't help you.


When must a router perform a recursive lookup on a route in the routing table?

show ip route B 200.100.50.0 1.1.1.1 First look the 1.1.1.1 next hop which is directly connected B 1.0.0.0 2.1.1.1 next hope is directly connected So 2.1.1.1 is directly connected and router start the uni-cast routing. this is a recursive lookup


What code is used in a routing table to indicate a directly connected network?

In a routing table, a directly connected network is typically indicated by the code "C." This designation signifies that the route is to a network that is directly attached to the router's interfaces. This allows the router to recognize and forward packets to these networks without needing additional routing protocols.


The Russian trade route was called the .?

This trade route was known as the Varangian Route. The Route connected Europe to Asia through the Russian territory.


Why Enable RIP v2 routing and advertise the participating networks?

The whole idea of a routing protocol, such as RIP, is that routers learn about other networks (those that are not directly connected) automatically. This reduces the amount of configuration needed, and allows the routers to adapt to changing conditions. For example, if a certain route is not available, an alternate route - should one exist - will be enabled.The whole idea of a routing protocol, such as RIP, is that routers learn about other networks (those that are not directly connected) automatically. This reduces the amount of configuration needed, and allows the routers to adapt to changing conditions. For example, if a certain route is not available, an alternate route - should one exist - will be enabled.The whole idea of a routing protocol, such as RIP, is that routers learn about other networks (those that are not directly connected) automatically. This reduces the amount of configuration needed, and allows the routers to adapt to changing conditions. For example, if a certain route is not available, an alternate route - should one exist - will be enabled.The whole idea of a routing protocol, such as RIP, is that routers learn about other networks (those that are not directly connected) automatically. This reduces the amount of configuration needed, and allows the routers to adapt to changing conditions. For example, if a certain route is not available, an alternate route - should one exist - will be enabled.


When do directly connected networks appear in the routing table?

Directly connected networks appear in the routing table when a network interface on a router is configured with an IP address and subnet mask, and the interface is in an "up" state. The router automatically adds these networks to its routing table as local routes, allowing it to route traffic directly to those networks without needing additional configuration or protocols. This ensures that the router can efficiently communicate with devices on those directly connected networks.


What was the trade route?

This trade route was known as the Varangian Route. The Route connected Europe to Asia through the Russian territory.


In the 1300s a land route and then a canal connected Lubeck with Hamburg why was the linkage so important?

because it brought goods into the interior


What was the trade route called?

This trade route was known as the Varangian Route. The Route connected Europe to Asia through the Russian territory.


What trade route connected Cordoba and Baghdad?

The Silk Route connected Cordoba to Baghdad and most of the rest of the ancient Asian and Middle Eastern world.


What is the Silk Route and what two areas did it connect?

the silk route is a route to china.