Dlci
pvc
Frame Relay
IP, Ethernet, Frame Relay, ...IP, Ethernet, Frame Relay, ...IP, Ethernet, Frame Relay, ...IP, Ethernet, Frame Relay, ...
show frame-relay map
Frame Relay is a packet-switching technology. It works by sending information in packets, which are called frames, through a shared frame-relay network.
Frame relay.
no
A means of providing access to the Frame Relay network over a DSL connection
Both ATM and Frame Relay are ways to connect your local network router to an ISP
There are various differences between X.25 and Frame Relay. The most significant are: 1. Call Control X.25 connection establishment and release (call control) use in-band signaling within the same virtual channel used for user data transmission causing additional overhead. Frame Relay call control uses separate virtual channels identified by reserved DLCI using the LMI (Local Management Interface) protocol. 2. Routing vs. Switching X.25 performs packet switching on OSI layer 3 (network layer); Frame Relay performs packet switching on OSI layer 2 (data-link). Frame Relay does not use any layer 3 protocol. 3. Flow Control Frame Relay (FR) doesn't perform flow control between frame handlers (FR routers). X.25 routers have to acknowledge each frame; in case of frame errors frames have to be retransmitted and acknowledged. Frame Relay relies on flow control performed by higher layer protocols.Source: http://www.synapse.de/ban/HTML/P_LAYER2/Eng/P_lay264.html
No. Frame Relay is not operating at Layer 3. Frame Relay is strictly a Layer 2 protocol suite, whereas X.25 provides services at Layer 3 (the network layer) as well. This enables Frame Relay to offer higher performance and greater transmission efficiency.
its Digital
networking purpose