0
Screw
Amit Nandy
Add your answer:
Earn +20 pts
What machine did Thomas Edison use to get all of the oxygen out of the light bulb?
his mouth
Will a light bulb light if its metal tip rests on metal casing?
The metal tip of a light bulb has to make contact with the bottom of the lamp holder's middle center contact to operate.
What instrument measures continuity?
A continuity tester, aka test light. Its a simple ohmmeter with a go/no-go indicator (often a light bulb).
Why does a light bulb light in a closed circuit?
A bulb does not light up if there is no voltage available across the bulb, or if the bulb is burned out.
Is light bulb a compound word?
No. The light bulb is two words, not a combination of light and bulb.
Is a light bulb a simple machine?
A light bulb is a simple machine. A light bulb is a screw.A screw is a simple machine.
What simple machines makes up the base of a light-bulb?
The bottom of a light bulb is a screw.
What simple machine is inside a projector?
A light bulb and a lens. In combination the form a machine to project an image.
What simple machines make up the base of a light bulb?
The simple machine that makes up the base of a light-bulb is just a screw. That screw allows you to insert the light-bulb into the base of a lamp. You must make sure to get the grooves of the screw lined up to properly tighten the bulb into place.
Is bulb a machine?
(Assuming you're asking about a light bulb.) No (By the way, you should specify what kind of bulb, and you need an indefinate article, such as "a" or "an" before your noun (which in this case is bulb) in this sentence.)
What type of simple machine is present in an electric bulb?
None.
Will two batteries and a wire make a light bulb light?
first of all, you need a bulb, a wire, and ONE light bulb. You clip the wire on the battery and touch the wire on the bottom of the light bulb
How do you change light bulb on viking sewing machine?
have old light out of machine but can't get new blub in place
What is the squiggly part of a light bulb at the bottom?
The base.
What is the metal bit at the bottom of a light bulb?
The Cap
What do you need to have a simple circuit?
Take a battery, a wire and a little light bulb. Put the wire on the flat part of the battery then put the other end of the wire on the side part of the bottom of the light bulb. Put the end of the light bulb on the top of the battery, dont touch the wire to the top when the light bulb is on it because is either shocks you or doesnt work.
How do you change light bulb on singer sewing machine?
There is a small hole on the top of the machine. Push the Elna screwdriver down into this hole with one hand. The bulb will pop out the bottom. Push the bulb up and turn anti-clockwise to remove.
