0
I was told it is
x(n) = 10*sin(2*pi*fo*Ts(n-1)) + 8*sin(2*pi*2*fo*Ts(n-1)) + 6*sin(2*pi*3*fo*Ts(n-1))
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What method of signal transmission uses radio waves to carry signals?
The analog method of signal transmission uses radio waves to carry signals. Digital transmission involves the use of satellites to transmit signals.
In wireless analog or digital signal travel?
Analog and digital signals can both be transmitted wirelessly. Wireless internet (Wi-Fi), for instance, uses digital. AM and FM Radio uses analog. Cell phones are digital. Cordless phones can be digital or analog.
Do digital signals control output?
No, some electronic devices use analog signals as their input/output others may use digital signals as their input/output; some equipment uses an analog signal as the input and outputs a digital signal. Be sure to use the correct signal and signal strength otherwise you may damage your electronic device.
Will a transducer from a lowrance x70a work with a lowrance hds 5x?
No The HDS 5 uses a dual frequency transducer (blue end), and the X70 uses a single frequency transducer (grey end).
What is disadvantage in amplitude modulation with carrier?
The differeces between frequency and amplitude modulation does not effect the range. Fundamentally the amplitude modulation system is less efficient in that a carrier is generated, which is modulated. The modulation power is half of the carrier power. The bandwidth required is twice the highest modulating fequency. Because of the small bandwidth required, the Amplitude Modulated band on radios is from 550 Khz to 1500 Khz. Channels are separated by 10 Khz, with actual users usually separated by 2 or three channels minimum. Frequency modulation varys the frequency of the carrier by the audio modulating component. While the frequency deviation can be as low as the audio frequency modulating the carrier, better noise performance is achieved by deviating the carrier by as much as possible. In commercial broadcast operations, the 15 Khz audio signal deviated the carrier by 75 Khz. This presents exceptionally good audio reproduction. It also causes the FM (Frequency Modulated) signal to occupy a band of about 240 Khz for a 15 Khz audio channel. This compares to 30 Khz for an equivalent AM (Amplitude modulated) signal. Because of the larger bandwidth required, the FM broadcast band is moved higher in frequency. This makes the other comments about range etc come into effect. AM signals can be received even when an interfering signal is present. Weak signals can be received in the presence of strong signals. Because of this property, Aviation signals, (Airplane to control tower and tower to plane) are in AM. FM signals have an effect called "capture effect" in which a stronger signal will capture the channel and eliminate interference from the weaker signal. Basically you are trading bandwidth for interference rejection. Because of this, signals from satellites, where the signal strength is extremenly small, used to be sent in FM. Present technology uses digital broadcast techniques. Talking about digital, because of the ability of digital receivers to process signals of extremely small size, digital signals are being sent along with both AM and FM broadcast signals for either better quality, or supplementary services. Cell phones are all being switched over to digital technology for better reliability and better channel usage.
What method of signal transmission uses radio waves to carry signals?
The analog method of signal transmission uses radio waves to carry signals. Digital transmission involves the use of satellites to transmit signals.
Which type of broadband internet uses the phone line to carry digital signals at high speeds?
Digital Subscriber Line (DSL)
Why did Congress order the change to digital TV?
Mainly to free up radio frequency spectrum. An analog picture uses 4.5 megahertz for the video and sound and a satellite transponder is typically 8 Mhz. wide. With the new digital system, it's possible to transmit up to eight separate TV channels in the same bandwidth on the transponder using a system called, `multiplexing`.
In wireless analog or digital signal travel?
Analog and digital signals can both be transmitted wirelessly. Wireless internet (Wi-Fi), for instance, uses digital. AM and FM Radio uses analog. Cell phones are digital. Cordless phones can be digital or analog.
What do you call a fiber optic cable in which the light signals follow a single path?
Baseband systems use digital signaling over a single channel. Signals flow in the form of discrete pulses of electricity or light. Figure 2.19 shows a baseband transmission with a bidirectional digital wave. With baseband transmission, the entire communication channel capacity is used to transmit a single data signal. The digital signal uses the complete bandwidth of the cable, which constitutes a single channel. The termbandwidthrefers to the data transfer capacity, or speed of transmission, of a digital communications system as measured in bits per second (bps).
What uses a digital signal?
Many television stations have been using digital signals for at least 30 years. They turned them into analog signals at the antenna for broadcast. Now they are simply leaving them in their original form.
What is the difference between discrete fourier transform and fast fourier transform?
discrete fourier transformer uses digital signals whereas the fast fourier transform uses both analog and digital.
Types of communication channel?
The two types of communication channel are analog and digital communication channel. An analog channel uses continuously varying (analog) electrical signals while a digital one uses discrete signals.
What is digital format?
A digital format is a format system that uses the digits 1 and 0 as codewords to interpret data received and data to be sent eg. a digital clock, computer signals.
Do digital signals control output?
No, some electronic devices use analog signals as their input/output others may use digital signals as their input/output; some equipment uses an analog signal as the input and outputs a digital signal. Be sure to use the correct signal and signal strength otherwise you may damage your electronic device.
Does relative frequency probability use group information and apply it to single cases?
Yes, relative frequency probability uses group information and applies it to single cases.
Whats the difference between baseband and broadband?
In Baseband, data is sent as digital signals through the media as a single channel that uses the entire bandwidth of the media. Baseband communication is bi-directional, which means that the same channel can be used to send and receive signals. In Baseband no frequency-division multiplexing is not possible. (Multiplexing (short muxing) is a process where multiple analog message signals or digital data streams are combined into one signal over a shared medium.)Broadband sends information in the form of an analog signal. Each transmission is assigned to a portion of the bandwidth, hence multiple transmissions are possible at the same time. Broadband communication is unidirectional, so in order to send and receive, two pathways are needed. This can be accomplished either by assigning a frequency for sending and assigning a frequency for receiving along the same cable or by using two cables, one for sending and one for receiving. In broadband frequency-division multiplexing is possible
