0
Which way do you turn the oil drain bolt to take off yz125 Yamaha?
Wiki User
∙ 10y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How is oil changed on 1986 yz125?
well on my 87 yz125 i take the drain plug out of the bottom of the motor to drain it then put it back in... then there is a little black like cap by the kick starter where you put the oil back in i use gear saver for mine...
Will a yz125 head and piston fit on a yz85 motor?
I seriously doubt it. This is something you need to talk to your local Yamaha shop about rather than take someone's word on it here.
What jets would you use for a Yamaha YZ125 2001?
It all depends on your locations.... take your stock settings and run the bike from there.... if your real high in altitude try taking your jets down a size and go from there
How do you rebuild a top end on a yz125?
Take her apart and rebuild that somebitch!
How do you check oil level in gearbox on a 2004 suzuki rm 250?
there will be a bolt on the right side by the water pump. take that bolt out and drain then fill it up till oil comes out the bolt..
How do you drain and fill the clutch fluid on a 98 Saturn SC2?
There is a bolt under neath the tranny. take it out and drain the fluid. ATF fluid 2.6 quarts is the capacity of the tranny
Would 2001 YZ125 Yamaha front forks fit on a 2003 TTR 125LE Yamaha?
I have a 2007 Yamaha TTR125L, and i am currently looking for Front forks for my bike also. A YZ125 front fork with triple clamps and all "should" fit all models of the TTR125, im hoping atleast. If your thinking of Re-doing the front end, the YZ125 is the best Choice. "NOTE" you will need a modified rear shock to balance out the setup of the front suspension or the bike will be unstable. YZ85 is to small, and YZ250 is probably to big. To be safe getting the front redone, install a stiffer shock(not just the spring) the whole shock, must be atleast 45% stiffer atleast!! Or take the bike to a shop, and get the rear shock redone, and modified for about $150 tops. Having a soft saggy rear setup with a stiffer MX style front is not safe!!!!
A 2001 Yamaha grizzly 600 stick shift freezes in the winter and requires twenty minutes to heat up and have stick shift work so what is causing this?
The pocket that the shifter sits in fills up with water, there is a drain bolt in the bottom or take it apart toget the water out. It is a pain in the neck in cold weather.
Will a yz250 motor fit in a yz125 frame?
Yes it will but it's not a direct bolt it. Some slight modifications will be necessary. Also may have to custom cut the drive chain. Take your time check and recheck all work, do it right the first time.
Where is the oil pan located on a 1991 ford f-250?
It will be on the bottom of the engine. You will have to get under the truck to see it. It will look like a big pan will one bolt on it. This bolt is what you take out to drain the oil out of it.
How do you take the seat off a Yamaha virago 750?
two bolt under the front seat left side and right side. they will be a metric Allen head
How do you adjust the valves on a Yamaha ttr-90?
you take the q square and the s value and multiply by 169 to get the bolt loose. then eat a large hamburger. your welcome.
