If you look at the top of the pistion you will see a small grove are slot that is right on the edge of the top of the pistion and it is only on one side. That mark,groove,slash,arrow are even a dot means that it points to the front of the engine.
towards the front of the engine.
On the front calibers they should move in when compressed, the back ones have to be screwed in.
Check the calipers. If the calipers pistons are extended to far - this could cause the brakes to lock up. The pistons cannot be retracted.
rear brake pistons are called actuated pistons. And the twist in and out. You will need a special tool to twist them back into the caliper. Unlike the Front Pistons which can be pushed back.
that depends if it is front or rear calipers
It is believed that images and figures of elephants should face towards the door of the room they are in to encourage good fortune. They should also have their trunks turned upward.
Look where the engine meets the transmission. It should be on the drivers side. should be in front towards the bottom.
Unlike the front calipers, pistons in the rear usually have to be rotated to compress them.
The cable teeth should face towards rear.
for a front side rodeo you are going to throw your back shoulder towards your front foot. for a back side rodeo throw your front shoulder towards your back foot. these two tips should initiate your spin. from there you should perfect this spin on a trampoline to ensure that you can complete the full 540 degree rotation on the snow.
Should be under the hood, on driver's side, towards the front. Should see 4 plugs plugged into it.
There should be an arrow on the top of piston , it points toward the exhaust pipe or the front of machine . Some pistons have holes in the piston these holes go toward the back of machine toward the carb .