Henry Ford produced the B24 Liberator bomber during WW2 .
a light on the inside of an automobile that is turned ON automatically when the door is opened.
Yes , once it's turned off and locked
Besides the smart alec answer "start an automobile", a starter has a small gear, that will both extend as well as rotate when the key is turned. This gear will engage teeth on the flywheel/flexplate, which is bolted to the rear of the crankshaft. As the starter turns, the engine will be turned.
c) be turned in kerosene.
by making love and foreplay
Lots of places. They turned lots of factories over to making parts for them, and did final assembly in several places. Two names that spring to mind are Castle Bromwich and High Post (near Salisbury)
The acc switch in an automobile is an accessory switch. It is used for listening to the radio or other electronic equipment in the car with the engine turned off.
Right hand and left hand threads differ in the direction they tighten or loosen. Right hand threads tighten when turned clockwise and loosen when turned counterclockwise, while left hand threads tighten when turned counterclockwise and loosen when turned clockwise. This difference affects the assembly process because using the wrong type of thread can lead to parts not properly securing or coming loose during operation. It is important to match the correct thread type to ensure a secure and stable assembly.
Mine had a clicking noise and it turned out to be the front passanger side axle assembly.
if this is turbo you could have to much oil in and it gets into the turbo and will run on its own
Horses still filled the main role of transportation for many years after the automobile was developed due the expense of buying a vehicle and then the fact that cars of that time were quite unreliable kept horses employed for transport services. However after the automobile became more mainstream horses turned into a pleasure animal and general farm labor animal.
To remove the headlight assembly from a Pontiac G6, first, ensure the vehicle is turned off and the keys are removed. Open the hood and locate the mounting screws or bolts securing the headlight assembly; typically, there are several that need to be removed. Disconnect the wiring harness by gently pulling it away from the assembly, then carefully pull the headlight assembly out of its housing. Finally, replace or reinstall the new assembly by reversing the steps.