0
Why Rpm fluctuation in tv3 turbo shaft engines of MI-17 HELICOPTER?
Wiki User
∙ 11y ago
two reasons
first: it is one spoole engine and have large amount of bleeding air distributed along hight compressor ,low compressor and combustion chamber
second:because of this it make adelay response of throttle liver and engine situation change
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What type of engine need rotor head?
Turbo Shaft Engines?
Are turbo-shaft engines louder than turbojet?
No, a jet engine is louder.
Types of gas turbine engines inlets?
the types of gasturbine engines are,turbo jetturbo propturbo fanturbo shaft
Why are airplne fater than helicopter?
because it has wings and turbo engines on it. Hellicopters have blades that can snap at any givin moment
T53 l13 turbo shaft huey helicopter?
Yes, the UH-1 Iroquois (Huey) had a jet engine. See the Bell UH-1 Iroquois website for for details.
How do two engines power a single rotor?
Turbo shaft engines deliver mostly all of the power to a gear box built into the engine, a separate transmission takes that power to the rotar . Lots of big heavy gears
Is a turbo the same as a turbo charger?
In the case of engines, turbo is used as a contracted name for the turbo charger.
How does a turbo prop work?
The turbo prop core is very much like a turbojet engine. The difference is that rather then expanding all the hot exhaust gases through a nozzle to produce thrust these gasses are used to turn a turbine. this turbine is connected to a drive shaft which is in turn connected to a gear box. A shaft coming from the gear box is finally connected to a propeller which produces most of the thrust. The exhaust velocity of a turboprop is does little to aid thrust as most of the energy of the core exhaust has gone into turning the drive shaft. The turbo shaft engine is a variation of the turbo prop. In this system the gear box is some other drive device. Turbo shaft engines are used in many helicopters, as well as tanks and boats.
What the different between a short shaft and a long shaft on turbo 350?
About 6 inches
Can you swap 95 eclipse turbo engine in to 98 eclipse turbo?
yes. both engines are the 4g63. the turbo engines from the 1990-1994 is a 6 bolt 4g63 and the turbo engine from the 1995-1999 is a 7 bolt 4g63.
How do you get the tail shaft out of 350 turbo trans. how do you get it out?
c4
Will the tail shaft interchange from a turbo 350 to a 400 turbo?
No it will NOT interchange. The 350 and 400 turbo are actually VERY different transmissions.
