A capacitor conducts AC but do not conduct DC because it is meant to store charge.
no
For part of the AC voltage wave, the capacitor will be above the source voltage, and will discharge until the AC voltage wave increases above the capacitor's stored voltage.
If a circuit is grounded through a capacitor it is referred to as AC ground because ac signal can pass through the capacitor DC level is blocked
Yes. A capacitor stores charge from any source, including AC.The difference between DC and AC, however, is that the capacitor will be constantly changing in charge, in step with the AC. Due to the nature of the capacitor, the current through the capacitor will lead the voltage by some amount, depending on capacitance and resistance. {In the ideal case of a perfect capacitor, conductors, and AC power source, the current will lead the voltage by 90 degrees phase angle.}This is called capacitive reactance.Another way for a capacitor to store charge from an AC source, of course, is to place a rectifier diode in front of the capacitor. This, then, becomes an AC to DC converter.
A capacitor doesn't step down AC voltage, that's what a transformer does! It really can't, no matter what the circumstances.
ac passes by repeatedly charging and discharging the capacitor. when you study ac circuit analysis, you will find out about impedance and reactance, which will allow you to compute how ac behaves in capacitors and inductors.
AC current can flow through a capacitor, it's DC current that can't
A capacitor is a capacitor, no matter what circuits you use it in. There is no difference between one used in AC and one in DC, except perhaps the size that is appropriate.
To test a capacitor on an AC unit, you can use a multimeter set to the capacitance setting. Disconnect the capacitor from the unit, discharge it, and then place the multimeter leads on the capacitor terminals. The reading should match the capacitance rating on the capacitor. If the reading is significantly lower, the capacitor may be faulty and in need of replacement.
To check an AC capacitor with a multimeter, set the multimeter to the capacitance setting. Disconnect the capacitor from the circuit and touch the multimeter leads to the capacitor terminals. The multimeter should display a reading close to the capacitor's rated capacitance. If the reading is significantly lower or higher, the capacitor may be faulty and in need of replacement.
Capacitor does not allow any current through it.By the changing of electric field across the plates it is usually assumed that capacitor allow ac through it.Is it???
If you mean run capacitor, as in the run capacitor for an AC motor, it is usually a round or oval cylinder.