Microprocessor processes something on each clock pulse
How do you interface a clock and microprocessor?
The clock signal in a microprocessor allows synchronization of several components of the microprocessor. The correctness of the computation of the microprocessor depends upon efficient and balanced distribution of the clock signal. The clock generator generates the clock signal.
It is the ratio of the on and off time or the clock signal, which is generated by the clock generator...
+5v necessary for microprocessor 8085.
The 8086 Microprocessor operate to require frequency that is provided by clock generator to 8086 Microprocessor and also Synchronization various component of 8086.
The central processor unit (microprocessor) is placed on the motherboard. The cooler, necessary to refrigerate the microprocessor is placed behind it.
Early microprocessor neded clock input to be given externally, i.e. an extra clock generator chip is necessary. the clock generator chip had two pins between which a crstal or an RC circuit could be connected for the generation of basic frequency desired. however, microprocessor, that were designed after 1978(Intel 8085, M6809, etc.) had the clock generator circuit embedded in the microprocesor chip.
that depends on the microcontroller. check the datasheet.
one is for the vcc and another for the clock pulse
A T state is one cycle of the system clock.
[url=http://www.dvdsuperdeal.com]A microprocessor[/url] is a multipurpose, programmable, clock driven, register based device that takes input and provides output.
vcm sdram