answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Why are the console gear shift steering wheel and headlight indicator lights not working on my 2011 Ford Escape?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Corsa right indicator not working?

try sticking left stick behind steering wheel up


The headlamp on your 1995 Honda Odyssey stopped working neither the high or low beam however whenever the key is turned on the high beam indication light on the speedometer is on Any suggestions thank?

replace the headlight. your indicator lamp inside the vehicle has nothing to do with your headlight working.


Why is the headlight and blinker not working on a 1997 Nissan altima?

One headlight not working


Signal lights are not working changed fuses bulbs flasher what else could it be?

How bout the turn signal indicator switch located in the steering column.


How do you change the burned out light on the shift console on a 1998 Oldsmobile intrigue?

STEP 1: Remove the console topOpen the console arm-rest and remove the two bolts near the latch.Lift the console from the now un-bolted end and carefully pry up from opposite end (there are 4-6 tensioning-pins holding the remainder of console top.BE CAREFUL - you have a plug in the console top for the traction control.Lift up the console top and adjust it out of the way.STEP 2: Remove the shifter position indicatorIf you're REALLY god at working in small spaces, you MIGHT be able to remove the bulb socket from the shift indicator without removing it, but realize you have to turn/twist the bulb socket about 90 degrees and then pull down.The bulb is on the driver's side of the shift indicator. Remove the indicator by removing four bolts and lifting up slightly to gain access. Twist the bulb out of the indicator module, replace bulb, and return bulb socket into the shift indicator.Turn ignition key on to assure the new bulb is working properly.STEP 3: Reassemble the consolePlace the shift indicator module back in place and put in the four bolts.Set the console top tension-pins into place and press back down working from dash-end back to console glovebox compartment.Insert the two console-top bolts back in at latch area of console glovebox.DONE!


My Interior Dome lights Radio and automatic headlights aren't working on 2004 Explorer XLT 4X4?

check the ignition switch under the console on the steering column


1998 Yamaha fzr 600 lights not working?

Check the main headlight fuse. Check the start button, it interrupts power to the headlights. If the high beam indicator and the gauge lights are out it could be this switch.


Why dospesn't my Gear shift indicator show which gear I am in?

Without knowing what car you have I couldn't say for sure but from my experience most cars with the indicator above the steering column it is caused by a broken nylon string that attaches from the indicator and the shift rod. These do not wear out often, most of the time it is caused by inexperienced people dropping the steering column or replacing the column. If it is not detached at the correct time in the sequence when working on a steering column it will definitely break the nylon cable. Addition: If it's a Buick Century or Regal, contact me at ANCTechnologies at hotmail and I can assist you.


What does a particular warning light on your 2002 Lexus ls 300 mean you do not have an owners manual and cannot determine what the light is telling you it looks like a headlight?

it is your fog lamp indicator saying it isn't working properly


The fuel and speedometer lights are out in your 1990 Chrysler New Yorker?

Of course ,first check the fusebox. If all fuses check out ok, I think the headlight switch is bad. I had a problem with indicator lights and my running lights were not working.(Tail lights,). I tried everything and finally replaced the headlight switch and that fixed it! About $25.00


Passat 04 tdi indicator lights are not working?

If a Passat 04 TDI's indicator lights are not working, check the fuse. A blown fuse can cause the lights to stop working.


How do you change a 2004 Nissan altima headlight bulb?

My headlight is not working on the passengers side. Do I need to change out the headlight assembly or can I simply change out the bulb? My headlight is not working on the passengers side. Do I need to change out the headlight assembly or can I simply change out the bulb?