I can't
It is the current transformer core meant for metering.
Transformer is based on the principal of mutual inductance.Induction is produced due to sinusoidal wave form thats why we use Alternating current inspite of Direct current.
A transformer can be used to change the voltage to an appliance. The voltage rating of the transformer should be right for the voltages used, and the current rating of the transformer should not be less than the current drawn by the equipment.
In transmission lines there is a massive current, we use CT to make this current measurable i.e. it steps down the current but DT is used to step down the voltage
Excitation current is the current necessary to "turn on" the transformer so it can be used. It's energy that is lost in the use of the transformer. Most of this loss I believe is associated with the hysterisis loop, although some will be lost as eddy currents.
use of CT
Electrical (alternating current)
You can use multiple appliances as long as long as you don't draw more current than the transformer can supply.
in welding machine, the transformer used is basically a current transforrmer. so by changing the tap of secondary side of transformer, we can increase or decrease the current in the transformer.
why does have to short-circuit secondary wire of current transformer ?
The primary current on a loaded transformer depends on the secondary current, which is determined by the load. So, if you know the secondary load current, then you can use the turns ratio of the transformer to determine the primary current:Ip/Is = Ns/Np
yes,we can change the transformer side in transmission line as use of high current or high voltage in output.