Yes. You can twist them together and wire nut them, or solder them together.
when it melts the metal part are joined together strongly
You can solder them after using a western splice connection. You can use a mechanical butt splice and you can connect the wires together with a wire nut after twisting the wires together. All you have to remember is that the insulation of the splice has to be equal to the wire insulation or greater.
Step 1) Twist the two parts together (only do this if you are soldering two wires together).Step 2) When the soldering iron is hot enough, tin the tip of it with solder or tinning compund.Step 3) Heat the parts that are going to be joined. DO NOT MOVE THE SOLDERING IRON.Step 4) Slowly push the solder into the heated area. Sing 1 2 3 4 5 once I caught a fish alive while you are doing this. This is becuase when you finish singing it, enough solder will have melted onto the joint.Step 5) Clean the tip of the soldering iron by rubbing on a damp sponge.Step 6)Leave the solder to cool and harden.u have to use the right type of metals but for like wires u would twist the two together like _ _ not like /\ under a wire nut and use a soldering stick to heat up the exposed part of the wire and brush the solder across and it will melt on it and down into it== ==Use the soldering iron to heat both the solder pad and the parts lead at the same time. Give it a couple seconds to heat up and then apply your solder, using just enough to cover the soldering pad and connect to the wire lead. Then let the connection cool. Be sure that the part lead doesn't move during the cooling phase or you'll get what they call a cold solder joint. It takes a little practice but it's no rocket science, either.The solder should be a `rosin core` solder. What that means is that the solder has soldering flux built into it which helps clean the connection after being heat activated and also helps to ensure that the solder will flow evenly as well as adhere to the metal.A cold solder joint looks grainy and dull in appearance. A good solder joint looks shiny. If you get a cold joint, reheat it and let the solder cool down again, and if necessary, it's OK to add a touch more solder.
are molecules are joined together to form elements
what wires are they? If they are just regular wires like for lights or something, the best method is to solder them back together with rosin core solder and cover them with heat shrink tubing what wires are they? If they are just regular wires like for lights or something, the best method is to solder them back together with rosin core solder and cover them with heat shrink tubing
Yes. You can twist them together and wire nut them, or solder them together.
when it melts the metal part are joined together strongly
One old trick to solder two wires is to twist them together and twist some solder round them as well, wrap them in foil and apply a lighted match.
Because it melts easily and is good in a solder mixture to hold wires together.
It can be used to mold wires together
cut the wires and the new solenoid will have the part to solder the cut wires together
You could solder them together and then tape securely with electrical tape.
Yes. Providing you maintain double insulation by means of heat shrink, a junction box etc.
Solder the wires together and use heat shrink to insulate the soldered connection. You can buy heat shrink at any auto parts store or hobby store.
Soldering is a way of joining one component to another component. Components on a printed circuit board are held in place with solder. Solder being a conductive compound lends itself very nicely in the electrical and electronic industries.
You can solder them after using a western splice connection. You can use a mechanical butt splice and you can connect the wires together with a wire nut after twisting the wires together. All you have to remember is that the insulation of the splice has to be equal to the wire insulation or greater.