The light buls maybe burn out. -------------------------------------------- Instrument Cluster Removal & Installation 1. Disconnect the negative battery cable. 2. Remove the cluster opening trim panel. 3. On vehicles equipped with an automatic transmission, remove the loop on the indicator cable assembly from the retainer pin. Remove the thumbwheel bracket screw from the cable bracket and slide the bracket out of the slot in the steering column tube. 4. Remove the instrumental cluster retaining bolts. 5. Pull the instrumental cluster out of the instrument panel. 6. Detach the electrical connectors. 7. Remove the instrument cluster. To install; 8. The installation is the reverse of the removal. 9. Connect the battery cable, and check the operation of all gauges, lights and signals. *** Turn the light bulb housing counter clock wise. Sometimes they are very hard to turn. Don't be afraid to turn them. ***
you cannot service panel lights on 2000 impala . you hav to replace the instrument cluster.
In the fuse box...it will be labeled panel, or cluster , if the fuse is okies its the light switch.What if it is only half of the lights on the instrument panel that are out? Just the cold/hot dial and 5 buttons?
your instrument panel lights can be dimmed(thumb wheel switch) down to practically no lights at all on your instrument cluster, this switch should be located most likely on the dash, left hand side of steering column. If this does not fix the problem ,then you have to check your fuse panel to see if you have a burnt out fuse.
Remove the dash and remove the instrument cluster, the lights are in the back of the cluster.
you take apart the dash and get to the instrument panel. then you take the instrument panel out and on the back of the panel you'll will see the lights
Either your IVR(instrument volage regulator) or a faulty connection from the harness to the cluster.
well i bought new lights for my instrument cluster thinking it would fix the problem but there still dim
The 91 Vandura G2500 Instrument Panel Cluster Relay is located on the dashboard.
remove the trim panel around the instrument cluster then remove cluster. On the back of instrument cluster are the bulbs just turn them half a turn and they come right out.
A blown fuse. Or a connection problem within the instrument cluster
All the lights a flashing on the instrument panel on my Chrysler town and country minivan. Why?
To fix the 1995 Suburban instrument lights, check the light fuse first. Check the light switch. If these are ok, then check the instrument cluster for proper power and ground connections.