The torque on a series motor is determined by the square of the armature current and, so, is very large -much larger than that of a shunt motor. Consequently, on starting, with no back-emf being generated, the torque on a series motor can be dangerously high if the machine has no mechanical load.
the basic difference is ,in short shunt motor the series field winding wont carry any current under no load condition whereas in long shunt motors series winding will carry no load current.....
Motor will rotate at very high speed leading to destructionAnswer from Kinindia.com
It is the resistance across the cell to invoke a constant draw. This makes the cell work efficiently under ideal conditions. To do it properly new cell management systems measure the temp. and voltage output and put a load on the cell that makes it work best.
It is submersible motor.
Connect the circuit as per the circuit diagram shown in fig1. Keep the field regulator of the motor in the minimum resistance position and regulator of the generator in the maximum resistance position.2. Switch on the supply and start the motor with the help of its starter.3. Adjust the field regulator of the motor such that it runs its rated speed given on thename plate.4. Adjust the armature regulator of the generator to build up its rated voltage given on itsname plates on no load.5. Note down the no loads of ammeter and volt meter in tabular form.6. Increase the load gradually in steps and tabulate the readings7. Plot the external characteristics is load current Vs terminal voltage.8 Connect the generator for differentially compounding, repeat the process and plot theexternal characteristics.
the basic difference is ,in short shunt motor the series field winding wont carry any current under no load condition whereas in long shunt motors series winding will carry no load current.....
it maintains a constant speed under varing load
The speed of dc shunt motor is practically constant under the normal condition because the field flux is constant.
Motor will rotate at very high speed leading to destructionAnswer from Kinindia.com
What kind of DC Motor? Different motors have different torque DC Motor Types * Permanent Magnet: No field coils at all. * Series Wound: the field coils are connected in series with the armature coil. Powerful and efficient at high speed, series wound motors generate the most torque for a given current. Speed varies wildly with load, and can run away under no-load conditions. * Shunt Wound: the field coils are connected in parallel with the armature coil. Shunt wound motors generate the least torque for a given current, but speed varies very little with load. Will not run away under no-load, but may if the field windings fail. * Compound Wound: a combination of series and shunt wound. This is an attempt to make a motor that will not run away under no load or if the field fails, yet is as efficient and powerful as a series wound motor. * Check this link: http://www.reliance.com/prodserv/motgen/b7096.htm
in case of cumulative generator series field flux and main field flux are of same direction and in case of a differential compound generator series field flux and main field flux opposes each other.
Because the field flux is constant.
outboard motor will start and idle, but dies out under load
crawl under the car an remove it
A compound generator is a type of generator that has both series and shunt field windings. The series winding adds to the main field flux, providing good starting torque and limiting voltage droop under load. The shunt winding ensures stable voltage regulation at normal load conditions by adjusting the generator terminal voltage. This combination of windings allows the generator to provide stable output voltage across a wide range of loads.
Use a 5W-20 grade motor oil.
It is the resistance across the cell to invoke a constant draw. This makes the cell work efficiently under ideal conditions. To do it properly new cell management systems measure the temp. and voltage output and put a load on the cell that makes it work best.