If the bolts have been removed and the wires disconnected, try tapping the starter with a wooden block to loosen it, Sometimes the starter will stick in place due to sludge and grime.
Cant Its the computer
Remove drive shaft and bring to a machine/auto parts store to have "U" Joint removed and new one pressed in ** If you can not afford that, you can use a vice to push the ujoint out and press the new one in.
Cant on a 91-96 the starter and solenoid are one piece. I assume its that way on all of them. Starter cost around 100 bucks at autozone with a lifetime warrenty
To remove the starter on a 1999 Mazda Protege LX 1.6L, you typically need to remove the intake manifold or throttle body to gain better access, as the starter is located in a tight space near the engine block. Disconnect the battery first, then remove any electrical connections to the starter. After that, unbolt the starter from its mounting position and lift it out. Make sure to take note of any vacuum lines or cables that may need to be disconnected to facilitate the removal of the intake components.
If you're talking about the older, air cooled beetles, you don't need to remove the tin. The starter is reached from UNDER the car. Disconnect the battery, put the back of the vehicle on jack stands or ramps. Climb under and you should see the starter RIGHT BESIDE THE TRANSMISSION. Remove the wires, remove the 2 mounting bolts and the starter should fall out.
you cant
you cant. All the Pokemon in Pokemon ranger cant be evolved. You can only catch the evolutions.
FIRST CHECK THE BATTERY IF GOOD]> THEN STARTER MOST LIKELY IS BAD ?
1997 olds achieva remove starter and wire plug got pulled out and we cant find where it goes? help?
the oil pan is stuck on sometimes and might need a flathead screw driver to pry it off the gasket sometimes acts like a seal then sometimes it dont
you cant
you cant