to provide a discharge path for voltages.
If you mean Christmas lights; that was before. Nowadays Christmas lights are connected in parallel.
An ammeter is always connected in series and a vlotmeter in parallel
it must be connected in parallel as always
Hi, Always interpoles are connected in series with armature. N.V.B.V. Prasada Rao
Yes, capacitors can be, and often are, used in DC circuits. At steady state DC conditions, the capacitor has near infinite impedance. Its value is in its ability to resist changes in voltage, so it can serve as a transient filter. There is almost always a small ceramic capacitor connected between VCC and ground next to IC's in a digital circuit, for that exact purpose.
Capacitors are one of the standard components in electronic circuits. Moreover, complicated combinations of capacitors often occur in practical circuits. It is, therefore, useful to have a set of rules for finding the equivalent capacitance of some general arrangement of capacitors. It turns out that we can always find the equivalent capacitance by repeated application oftwosimple rules. These rules related to capacitors connected in series and in parallel.
in parallel
If you mean Christmas lights; that was before. Nowadays Christmas lights are connected in parallel.
An ammeter is always connected in series and a vlotmeter in parallel
No. They are parallel only in RIGHT prisms or RIGHT cylinders. However, they are almost always parallel for school level questions.
Voltmeter should be connected always in parallel to a circuit ANSWER : IT should be in parallel except when used to measure current. Then it should be placed in series across a shunt.
only two connections are possible.. parallel connection is always desired than series. .
An ammeter is connected in series. A voltmeter is connected in parallel. ammeter should always be connected in series instead of parallel becoz it is a low resistance device and we know that resistance is inversly proportional to current so more current will pass through it and if it is connected in parallel than it may get damaged
it must be connected in parallel as always
Hi, Always interpoles are connected in series with armature. N.V.B.V. Prasada Rao
House wiring is almost always parallel. Series wiring may be used for some switch circuits, however.
If they were in series in the circuit, they would act as on/off switches.