0
Why cold reheat has more safety valve than hot reheat in boiler?
Wiki User
∙ 13y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where on the hot water boiler is the shutoff valve?
Usually on the top, on the incoming cold pipe.
What is the best way to reheat sushi?
you don't reheat a sushi.. Sushis are eaten cold...
Where is the cold start valve 1990 5.0 bronco?
Cold Start Valve. Cold start valve. I do not believe there exists a "cold start valve"
What is the problem when you have hot water in only half of the house?
Assuming a single boiler, if some location is not getting cold water either a valve is closed or a line is blocked with mineral deposits.
What you mean by cold differential set pressure of a safety valve?
cold differential test pressure -The inlet static pressure at which a pressure relief valve is adjusted to open on the test stand. This test pressure includes corrections for service conditions of superimposed back pressure and/or temperature.
Shut down condition coal fired boiler?
Cold
Why does a house boiler pressure relief valve drip water constantly?
if it's dripping water constantly even when cold most likely your pressure reducing valve on the in coming water is letting in more water than it should causing the pressure to rise, if it just happens when the boiler is calling for heat it's probably your expansion tank, it could be water lodged and needs to be drained and re pressurized or replaced. make sure the pressurizer relief valve is not dripping before your boiler reaches 30 psi, that's what they are usually set for on house boilers, if it is dripping before reaching 30psi it's a faulty pressure relief valve that needs to be replaced
Can you reuse cheese sauce after it has been heated in the can?
yes you can put it in the fridge and it will get cold again and you can reheat it.
How many type of turbine cold startup?
water tube boiler
What is the purpose of a cold air return with boiler heat?
None. Probably the home was built for forced air and converted to boiler/baseboard heating.
How boiler safety valve works?
most common type, the section VIII Safety-relief valve operates on force-balance. One standard orifice is 0.196 square inches. Standard orifice designations are D through T, with D being .110, and T being 26.0 square inches if memory serves. If you need to set the valve to pop at 500 psi, first the manufacturer or a certified repair facility would select the proper spring for the application. Then they crank the spring adjuster down so that the preload is 0.196 x 500 = 98 lbf. Now, when the pressure under the disc gets to 500 psi, the disc will begin to lift. Outside of the disc there is a ring, which may or may not be adjustable. As the disc begins to lift, the flow starts, and it hits the ring and is deflected downward, increasing the lifting force on the disc assembly. The disc then POPS open to its full allowable travel. As long as the pressure remains above setpoint, the valve remains fully open. The rated flow for the valve is measured at the cracking (set) pressure, +10 percent overpressure. Once the pressure goes below the set pressure, the valve is no longer held open by the inlet pressure and it closes. Code valves must close within 10% of the set pressure. Non-code valves sometimes blow-down considerably more than that. It is a bad idea to operate normally at higher than 90% of set pressure because if you get an upset and burp the valve it will stay open until it blows down to its reseat pressure. It's possible for the valve to stay continuously open if the system can supply enough flow at over 91% of the set pressure to keep it open. Safety-relief valves are like fuses....they are never really expected to operate, but are there to protect life and property in case of another malfunction.
What is the difference between a Hot water shut off valve and cold water shut off valve?
the hot water valve shut off valve shuts off the hot water. The cold water valve shuts off the cold water. ;()
