0
Factory defect? Something rock etc. thrown up under vehicle?
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How Do you Take Off A 1969 Pontiac Harmonic Balancer?
With a harmonic balancer puller.
Where should your timing mark be on a Pontiac 326?
It is located on the harmonic balancer.
Where is the timing mark on a Pontiac 326 v8 engine?
on the harmonic balancer.
Why does the harmonic balancer on a 1994 Pontiac Bonneville ssei supercharged keep breaking?
The most common reason for the harmonic balancer breaking on a 1994 Pontiac Bonneville SSEI is the inner and outer mass is breaking the balancer down. This happens because your engine is running rough or too high of RPM's.
What is the knocking noise in engine 3.8 liter Pontiac grand prix?
Replace the Harmonic balancer
Where is the crankshaft sensor on a 1995 Pontiac Firebird?
It is behind the Harmonic balancer at the bottom pulley on your motor.
What will happen if harmonic balancer breaks on a 1990 Pontiac Bonneville?
The balancer is attached to a flywheel that drives the serpentine belt for the water pump, power steering, etc. If harmonic balancer doesn't work, belt won't run, and eventually, neither will the car.
Crank sensor location on a 1989 Oldsmobile delta 98?
The crank sensor is located behind the Harmonic balancer. Try not to break the rubber within the Harmonic balancer when removing or on the safe side replace both the Crank sensor and the Harmonic balancer ( the big pulley on the bottom - most part of the engine.)
How do you install a harmonic balancer on 2002 impala?
do the harmonic balancer have a seal for anti-freezer
How do you replace harmonic balancer in 1999 Lincoln town car?
Harmonic balancer replace
Were is the crank sensor on a Pontiac grand pri?
The crankshaft position sensor is located behind the harmonic balancer. You will need a harmonic balancer puller and an impact wrench good for at least 750 ft pounds. Access the harmonic balancer through the passenger side wheel well. Remove the harmonic balancer center bolt and use the puller to remove the balancer. Use 1/4 - 28 X 3 inch bolts on the puller. The sensor is held with two screws. Be careful not to damage the weatherpack connector when releasing it from the sensor.
Where is harmonic balancer in 1996 Olds eighty-eight?
The harmonic balancer is located on the front of the crankshaft
