diesel's dont produce enough
As a diesel engine does not have a throttle valve in the air intake, no useable depression is created in the intake manifold. That is why diesel engines are fitted with vacuum pumps to operate the brake servo.
on the intake manifold near housing
your intake manifold gasket is cracked...replace it and you should be fine...if it continues you may have a bigger problem
The intake manifold is where the air and fuel mix and enter the engine. The exhaust manifold is where unspent gas and air exit the engine. In other words the intake manifold is where the engine breathes in and the exhaust manifold is how the engine exhales out.
The relay is behind the intake manifold near the firewall.
The intake manifold attaches to the heads of the engine and send an air and fuel mixture to the combustion chamber through the intake valves. The intake manifold is usually situated on the top of the motor.
It is located on the front of the engine, under the intake manifold.It is located on the front of the engine, under the intake manifold.
It is the area of the engine where the fuel and air go into the engine. It usually hasthe fuel injectors connected to it. It is bolted to the engine. An intake manifold is used on most vehicles. The intake manifold delivers theair & fuelmixture to the combustion chambers of your engine for ignition.
its on the side of the engine! behind the intake manifold... between the intake manifold and the firewall.
On a flat spot ground into block, on the left center of engine, just below intake manifold.
The intake manifold, on your Jeep grand Cherokee, is located on the front side of the engine. The exhaust manifold is bolted to the engine.
Assuming this is a 4.3L engine, the upper intake manifold gasket would be between the upper intake manifold and the lower intake manifold.