Want this question answered?
1. stain with leishman stain for 3 minutes 2. poured with buffer solution for 10 - 15 minutes, make sure the blood film is flooded with the buffer solution. 3. rinse with distilled water to clean the remaining stain. 4. air dry. this is the most simple step and easy to remember! good luck!
Because if the cells are fixed on the slide then the stain won't stick to them.
You can certainly expect the blood cells to stain the water as their cell membranes rupture from being in a hypotonic solution. The term that describes this is "To lyse". Blood cells lyse in distilled water.
Gram positive bacteria stain violet due to the presence of a thick layer of peptidoglycan in their cell walls, which retains the crystal violet these cells are stained with. If the violet can be washed out and the counter stain (pink) is added, the bacteria are Gram-.
The first stain is crystal violet, next iodine is added which acts as a mordent. Then, alcohol is added which will wash away the purple color from any gram negative bacteria. The purple color will stay in the gram positive bacteria due to their thich peptidoglycan layer. Lastly, Safranin is added as a counter stain. Gram - is red Gram + is purple
1. stain with leishman stain for 3 minutes 2. poured with buffer solution for 10 - 15 minutes, make sure the blood film is flooded with the buffer solution. 3. rinse with distilled water to clean the remaining stain. 4. air dry. this is the most simple step and easy to remember! good luck!
6.8
Because if the cells are fixed on the slide then the stain won't stick to them.
Supposedly, a "poultice" made of hydrogen peroxide and distilled water, left to sit on the stain, will draw it out.
0.15g of leishman powder dissolved in 100ml of distilled water
Probably not (if it's distilled vinegar), but it's possible. Water can stain some delicate fabrics.
Fill two spray bottles, one with six parts distilled water to one part soap and the other with pure distilled water. To spot clean taffeta, lay the garment with the stain facing up on an ironing board and place a clean white cloth underneath the stain. Spray the stain with the soap solution until it is gone. Change the cloth underneath if it becomes too wet. Spray the area where the stain was with the pure distilled water and press a clean cloth over it to absorb excess moisture. Place another clean cloth underneath the wet area and allow to air dry.
There are several good wood stain removers out in the market today. One could use distilled alcohol or several other commercial chemical strippers. One could also simply sand the wood.
There are several good wood stain removers out in the market today. One could use distilled alcohol or several other commercial chemical strippers. One could also simply sand the wood.
You can certainly expect the blood cells to stain the water as their cell membranes rupture from being in a hypotonic solution. The term that describes this is "To lyse". Blood cells lyse in distilled water.
Tap water is used to wash the excess stain from a slide prepared from a smear. You can use tap water instead of distilled water because you aren't worried about a precipitate forming and tap water is much cheaper than distilled.
Begin with performing a gram stain: heat the loop in the Bacti-Cinerator to sterilize it, dip it in the unknown culture, place a dime size amount on a glass microscope slide, heat fix the emulsion by applying a clothespin and running through the flame until dry, apply Crystal Violet stain for 1 minute, rinse with distilled water, apply Iodine for minute, rinse with distilled water, decolorize with 95% ethanol for 10 seconds, counter stain with Safranin, rinse with distilled water, gently blot dry in bibulous paper. Apply 1 drop of water and cover slip, observe under a microscope with oil immersion.