0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Were do you put your oil in banshee Yamaha 350 twin?
Transmission oil? It goes in where the dipstick screws into the RH engine cover near the kickstart lever. Top end oil? The Banshee runs on premix. You mix oil with the gasoline, put it in the fuel tank.
Can you put screws into a live tree?
Yes. usually people put screws into a tree for the trees benifit. To keep the tree standing straight by screwing a post into it. Although your screws shouldn't be to big so they dig to deep into the tree.
2000 Toyota Tacoma 2.7 liter oil pump removal Screws are starting to strip?
If the oil pump screws are starting to strip during the removal process on a 2000 Toyota Tacoma 2.7 liter, the hole will need to be repaired. A Helicoil insert can be put into the hole to replace the damaged threads along with new screws.
Where is the oil sending unit located on a 1995 Ford Thunderbird V8?
i just put a 4.6 in a 1994, the oil sending unit is located right on the oil filter bracket, ( where the oil filter screws on ) it has one wire that pushes onto it,
Name a type of oil people never put on food?
motor oil
Why do people put magnesium oil on their feet?
moisture
How do you replace transmission pan on 1998 Plymouth neon?
The transmission is on the right hand side in the front near the tire. There are 12 10mm screws holding it on. Start from the back screws with your catch pan underneath to start catching oil. Slowly start removing screws and letting oil drain. Wait to take last top 4 screws out till oil slow/stops draining. Remove last 4 screws and leave oil pan under transmission. Make sure to put gasket and sealant on new pan. I found it is a lot easier to place all screws in holes of pan then put on the same way you took it off. Refill transmission with 4 courts transmission fluid and start her up. make sure you don't have any leaks once started. Then you should be good to go. Good luck!!
How do you change the oil pump in a 1999 Cadillac escalade?
drain motor oil, remove oil pan , locate oil pump , it has 2 crews. replace oil pump with new one. replace oil pan gasket with new , put oil pan back make sure all screws are tight but not tooo tight . put back motor oil 4 1/2 to 5 quarts .. done check for leaks around oil pan.
How do you install the side body panels on 1985 El Camino?
take the screws out on both sides and put it in and put new screws in
What causes people to put oil in the ocean?
They don't mean to, its an oil SPILL, like it spilled, not on purpose.
How do you change a Mazda 626 transmission?
Jack up the front of the car and make sure it is safe. Then loosen the screws that hold the pan under the transmission. Careful there is a lot of oil in it so its better to take all the screws out except a few that will still hold the pan while you get to the side of it and then once all the screws are out then you can gently lower the pan down. Drain the oil out safely and clean the pan as well as any iron filings on the magnet. Take the old filter out from under the transmission including the seal and also gasket around where the pan fits on and clean it all. Put new seal and new filter in and then put the gasket on the pan and tighten screws to fix it to the transmission. Do not over tighten screws, just enough and all evenly around the pan. Put car down and take jack out. Put new transmission oil in and then start the car and let it idle for a bit and then check the dipstick to see how much more oil to put in. Check under car to make sure no oil is leaking. Can take car for a run and then check oil again while car is idling and top up if necessary. Regularly change transmission oil and filter at least every 100 000km or 12 months even earlier. Take care of car and drive safely.
Why is a pan made out of oil?
pan is not made of oil, but people usually put oil on it so cooking wouldn't stick to the pan.
