Want this question answered?
Through a relay or some other kind of high voltage switching device.
A: Depends on the meter it measure ohms, voltage, current. some may test for transistor beta health of battery and then some
we use grounded electrical circuit to prevent high voltage from any type of electrical source. with the help of grounded electrical circuit we by pass the high voltage to the ground. in common language we call it earthing.
It's dangerous at high voltages.
A: A doubler can increase a low voltage to a very high voltage by adding stages the application is study of high voltage behavior to plasma study to entertainment of globe arcing to ions generators to eliminate odors
The balls on some power lines are required so that airplane pilots will be able to avoid flying into the lines.
An electrical relay uses a low voltage, low current signal to control an electromagnet. When current passes through the electromagnet, it attracts the spring loaded arm with contactors, which will touch some stationary contactors, closing a circuit on a higher voltage/high current circuit. An example of this is when your thermostat 'tells' the air conditioner to turn on. The voltage & current from the thermostat are low, while the voltage & current necessary to run the air conditioner's compressor are high..
Through a relay or some other kind of high voltage switching device.
High voltage tests are done usually at the request of electrical engineers. When conductors are pulled into a conduit system, it is supposed to be done very carefully. In some instances this can not be done with out subjecting the conductors to mechanical stress. A high voltage test is applied to these conductors to make sure that the insulation factor of the wire has not been compromised. If the conductors do not pass the test, they have to be removed and new wire reinstalled.
Hi, The main difference is Fuel consumption. High current genertors always consumes much fuel because the load on the engine will be high. The high voltage low current generators doesn't need much fuel to run. You can understand this by comparing 1 kva and 5 kva single phase generators. For both generators voltage will be same (230v) But output current differs. So the fuel consumption also differs. But you get a high current source. Low voltage high current generators can be used for welding kind of stuffs which needs high current to do the job. If you have step down transformer then you can save the fuel.
Some believe that the first voltage source in the world was the Baghdad battery. In some temples, potery has been found that contains the components to create an electrical charge in order to produce voltage.
A: Depends on the meter it measure ohms, voltage, current. some may test for transistor beta health of battery and then some
vaccum cleaner, scrubbing machine
It's a description of the some of the electrical properties of the transformer. This is a Delta connected highside (the D), wye connected lowside (Y) that is grounded (N) and there is a 330 degree phase shift between the highside and the lowside (the low voltage is leading the high voltage by 30 degrees).
we use grounded electrical circuit to prevent high voltage from any type of electrical source. with the help of grounded electrical circuit we by pass the high voltage to the ground. in common language we call it earthing.
The amount of voltage that is contained in the electricity lines above the train could kill some one if they were even several metres away.
It's dangerous at high voltages.