It's a description of the some of the electrical properties of the transformer. This is a Delta connected highside (the D), wye connected lowside (Y) that is grounded (N) and there is a 330 degree phase shift between the highside and the lowside (the low voltage is leading the high voltage by 30 degrees).
No
Center tap transformer is the such kind of transformer that is made to a point half way along a winding of a transformer.
why should we use pulse transformer rather than ordinary transformer
The function of the radiator ban in a transformer is to cool the transformer oil.
A transformer is fundamentally a set of coils; therefore, a transformer is an inductive load. However, by "transformer load", you seem to mean "the load that is connected to a transformer". Whether that load is inductive or capacitive depends mostly on what is hooked up to the transformer.
there is no specification of Dy11.. it will be Dyn11.. it is the vector group of the transformer. capital d means primary winding is delta secondary winding is star(y) and the secondary current lags voltage by 30degree this angle when shown in clock will be looking like 11 o clock
The phase shift is caused by inductance in the transformer. Any inductance from magnetic flux that fails to link both windings is called leakage flux, and the resulting inductance is called leakage inductance.
No
you keep the hv & lv on the dyn11 tx straight in phasing. you then put a cross on any two phases on the hv side of the dyn1 tx, and do the same cross with the phases on the lv side of the tx. for instance lets say we cross a & c phases on the hv & lv sides of the dyn1 tx. now draw a diagram with the four tx, split them up, 2 x dyn1, 2 x dyn11. now on the diagram where you have dyn1 tx, change the the phase plates to read cba left to right, also change the lv side to match. leave the phase plates on the dyn11 tx alone to read abc left to right on both sides. now draw the cables going between them on the hv & lv sides. now if a phase always goes to a phase and b & c phases do the same it will all tie in. prove it to yourself and follow a phase threw all the tx's, do the same will b & c phases. I do it all the time at my job, works every time.
They all have delta primaries and star secondaries, possibly earthed. The number is the angle of the secondary voltage's lag behind the primary's, expressed as an hour on a clock-face. 11 --> Secondary leads primary by 30 degrees 1 --> Secondary lags primary by 30 degrees 5 --> Secondary lags primary by 150 degrees, making the red secondary voltage lag the yellow primary by 30 degrees (using UK Red/Yellow/Blue phases) Dyn11 and Dyn1 are much more common than DYn5
a hole transformer
DYn1 = Delta connected highside winding, Wye connected lowside winding, neutral brought out, lowside lagging by 30 degrees DYn11 = delta connected highside winding, Wye connected lowside winding, neutral brought out, lowside leading by 30 degrees In a DYn1, the lowside A phase is coupled to the highside A-B leg. In a DYn11, the lowside A phase is coupled to the highside C-A leg. So to convert one to another, you must physically change this coupling, which would require rewiring the internal connections of the transfomer delta.
Transformer has windings
yes we can place auto transformer in place of original transformer
The function of fans in a transformer is to regulate the transformer's temperature.
A transformer that increases voltage is a step-up transformer.
Center tap transformer is the such kind of transformer that is made to a point half way along a winding of a transformer.