0
a hole transformer
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is the purpose of the transformer in the half-wave rectifier circuit?
what is the function of transformer in the half wave rectifier circuit
What is center tap transformer?
Center tap transformer is the such kind of transformer that is made to a point half way along a winding of a transformer.
Who got ripped you half in the transformer movie?
Jazz, i think he was a Pontiac solstice
What is the name of the transformer what snapped the building in half in transformers 3?
Soundwave / Shockwave
What is centre tap transformer?
In electronics, a center tap is a connection made to a point half way along a winding of a transformer or inductor, or along the element of a resistor or a potentiometer. ..
What is TUF for half wave rectifier?
It indicate how well the input transformer is being utilized. It is given by the ratio of DC output power to the AC power rating of Transformer.
How much is the transformer utilisation factor for half wave rectifier?
0.287. I hope this is an academic question and not something you're thinking of using in a circuit; three more diodes are cheaper than the kind of filter you'll need to clean up the output of a half-wave rectifier - AND you throw away half the voltage the transformer is putting out!
What is the difference between an ordinary transformer and a center-tapped transformer?
An ordinary transformer has two input/output terminals but a center tapped transformer has 2 input and 3 output terminals. One is taken from the center for a ground connection. This causes it to get 50% of the actual value. And ordinary transformer contains 2 windings. An autotransformer has one.
When 2 power transformers are operated in parallel what would be the net capacity Is it less than the total capacity of above transformer?
iT is above Transformer because The Two power Transformers are operaTed iT for The same shape buT cuT in half
Why induction transformer called rotating transformer?
Transformer has windings
What is the use of ring main unit?
ring main unit is distributing the power supply to meter cubicalAnswerA ring-main unit (rmu) is a piece of switchgear that is used to connect a transformer's primary winding to a high-voltage ring main. It consists of three load-breaking switches, each with three positions: 'on', 'off', and 'earth'. They enable the transformer to be connected/disconnected to the ring; the ring to be 'broken'; or the transformer to be connected to either half of the broken ring. The 'earth' positions allow the transformer's secondary to be earthed, or either half of the (broken) ring to be earthed.
In D.C supply the transformer is not connected why?
In a DC power supply a transformer is connected. The only time there would be no transformer used would be if the DC voltage wanted was 120 VDC. The transformer in the power supply is connected to 120 VAC on the primary side and the secondary side of the transformer is connected to either a half wave or a full wave diode bridge. The voltage out of the diode bridge will be the same output voltage potential as the transformer's secondary voltage but it will be a DC (Direct Current) potential.Reading the question in another way, transformers are not connected in a DC circuit. The reason being is that the transformer operates on a collapsing magnetic field. This field induces a voltage into the secondary side of the transformer. Since the DC circuit does not operate on the principle of a collapsing field except when the circuit is opened, the transformer would not operate as a transformer should..
