It is probably the brake lights that are on due to a misinstalled or damaged brake light switch.
Blown fuse, failed bulbs, bad switches, etc.
No, the fog lights have a switch.No, the fog lights have a switch.
turn signals won't work. changed all the bulbs. Hazard lights work. 1999 Chrysler Sebring hardtop
To turn on the fog lights you pull the end of the turn signal lever it will pop out about 1/8th inch.
the multifunction switch... ( turn signal) twist it to turn on the lights and once the lights are on pull it towards the door to turn the fog lights on
Could be a faulty relay!
On my 2001 sebring, my light lever is on the column. After turning on my lights, I gently twist the end portion of the lever out (toward the door) to get the fog lights on
The primary causes for the lights to flicker inside on a 2002 Chrysler Sebring LXI is a loose bulb or wire. This can occur when the vehicle has experienced rough road conditions and excessive vibration.
A warning light on the dash board of a Chrysler Sebring that has an exclamation point has to do with the tire pressure monitor system. Another warning that is a solid light is referring to air leaking into the gas tank.
I have a Chrysler Town & country. My dash lights also went out. I purchased a Chilton's repair manual and gives fairly good instructions on doing it yourself. Takes about 20 minutes. The manual is about $25.00. Guarantee you'll pay around $150+ for this repair at the dealership.
it has a blown fuse
The part number for a 2000 Chrysler daytime running lights relay will be different for each manufacturer. Standard Motor Products sells this part as number RY-254.