0
Why do valves stick only when engine starts to warm up and not cold?
Wiki User
∙ 11y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why does a really cold Popsicle stick on your tongue?
It's the same concept as licking a pole when its cold outside.
Why does it become bitterly cold when ice starts melting in the cold countries?
Just don't live in cold countries and it won't be a problem
How do snowflakes stick to the ground?
The ground freezes, then the ground in cold enough for the snowflakes to freeze to it.
What size pipe is recommended for the hot and cold valves on a electric hot water heater?
Depends on the size of the heater Commerical etc
What is a snow refrigerator?
A snow refrigerator is when you stick your drinks and cold food in the snow to keep it cold... Just in case you wanted a cold drink right after the heated snow ball fight.
Valve clearance for tata 697 engine?
Intake valves - 0.20mm (Cold) Exhaust valves - 0.30mm (Cold)
What causes a 91 colt to have no compression and not start when its cold but once the day starts warming up it has compression and starts?
Adjust the valves, when its cold the metal shrinks and the valves stay open when the day starts warming up, or friction from turning it over and over will heat the block and expand the metal closing the valves that's why it starts in the day or when its warm. adjust the valves and it will start every time.
What is the valve clearance for Isuzu 4he1 engine?
0.016" cold both intake and exhaust. valves closed
What is tappet clearance for Lister ST1?
0.152mm or 0.006 inches on inlet and exhaust valves when engine cold.
Why do Toyota dash lights stay on after engine starts?
A bad relay switch could be the culprit if dash lights remain on after engine starts in a Toyota. Cold weather can also cause these lights to stay on after the engine starts.
Why engine only starts better when cold?
It could be sticky or worn valve parts.
Valve clearance Isuzu bighorn 4jg2 engine?
Valves should be adjusted cold (70ºF ) at .016" for both intake and exhaust valves. As usual, make sure cylinder is at TDC when adjusting.
Heater starts to turn cold when at stop light - what causes that?
The #1 cause of cold air from the heater when the car is stopped, or the engine is idling, low engine coolant levels.
Why does your 3 liter engine tick when cold?
Any engine can tick or have a slight knock or ping to it when it is cold. It's pretty normal. As an engine warms up the metal expands. Most of the time it's the valves/valvetrain. Some times it could be a bit of piston slap. Basically, as the valves expand when the engine gets up to temperature, the slack is taken out of it. I would suggest letting your car warm up before you drive off. Running a cold engine hard can lead to excessive wear.
What would cause a Nissan starts when is cold but won't start it is hot?
Check the engine coolant temprature sensor it may be sending the wrong signals to the ECU making the ECU think the engine is cold and overfueling the engine.
What is the valve clearance for Isuzu 5.2l diesel?
Engine needs to be cold when performing overhead adjustment. Spencer's is .16" intake and exhaust valves closed.
Can you adjust the valves on a 350 cold?
yes
