At night, there is no sun, thus there is no heat. When there is no heat, solids contract. The wires, being solids contract at night and in the morning, when there is heat, they sag.
you put the wires under the screws and tighten them
Check your battery terminals. The connection is lose, so just tighten up the bolts on the terminal and that should fix it. If that doesn't fix the problem follow the wires that come off your battery and make sure there is no wire showing. If so replace that wire. Follow the wires and tighten up any and all connections.
With a torque wrench that displays inch-pounds. Not too often foot-pounds. Or tighten with wrench or screwdriver until snug. Then move wires back and forth and tighten until snug again.
I believe he is constipated and needs a mild laxative or suppository.
Sure just tighten them up. If need be, just cut the ends, strip off a little insulation & crimp on new connectors, then reinstall.
Tighten Up - Electronic song - was created in 1991.
usually this is done at the ebrake itself. there are two wires going to it.
At night, there is no sun, thus there is no heat. When there is no heat, solids contract. The wires, being solids contract at night and in the morning, when there is heat, they sag.
hoist it into place and tighten the 2 straps, hook up your fuel line to the tank and the hot and ground wires for the fuel gauge and your ready to roll.
Hey Michael==Either you have a loose connection or more likely the speaker wires run aloung the light wires and the inductanc of the light wires are producing vootage on the speaker wires. Try it at night withourt the lights on. GoodluckJoe
Howlin and tighten up They played Lonely Boy and Gold on the Ceiling on 12/3/11
You can not tighten a T-Rod end up. If it is loose then replace it.