Hi,
If you are intending on bypassing the factory installed AMP you will have to connect the speaker wires directly to the stereo that you will be putting into the vehicle. However keep in mind that on some vehicles the AMP is connected secretly in the harness wires of the speakers and will not always work with an aftermarket radio....a good example are the stereos on Chrysler cars.
Thanks
bypass the factory amp
to bypass a amp you would have to run wires from the radio to the rear speakers or just cut both wire that go to the amp and got to the speaker and spice them togather i have a 94 mustang and it does sound like s_ _ t
Use Metra kit 70-8116 wiring harness to bypass the jbl factory amp on a 2000 Toyota Highlander. JBL amp is located behind the passenger quarter panel.
you dont
All you have to do is buy a bypass harness from http://www.installer.com/item/display_item.php?it=70-5513 That should take care of your stock amp.
You can find a speaker wiring diagram Dodge Ram 2005 with infinity amp bypass by visiting the nearest Dodge authorized repair center.
on mine i had a premium sound system package stock. i had to bypass the stock amp to run the head unit even though i am running it on the pre amp from the head unit. the speaker will notwork unless you bypass the the stock amp.
They make bypass plugs you can get at best buy or anywhere that sells car audio.
To install an amp to a factory radio of a 2012 Dodge Ram 1500, ensure that the amp bypass the harnesses.
get the after market wiring harness
Bypass it, you will have engine noise if you try to intigrate with it.