answersLogoWhite

0


Best Answer

The yogurt helps to tenderize your meat.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why do you cover meat with yogurt then remove it before cooking?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can you leave peeled potatoes two days before cooking?

Yes, just cover with water and refrigerate. Right before cooking, drain and pat dry with paper towels.


Does SIC 2024 cover frozen yogurt?

Makers of frozen yogurt are classified under SIC 2024


How do you remove a valve cover on a 1996 Hyundai elantra?

CAUTION: Some models are equipped with anti-theft-radio make sure you have the activation code before disconnecting battery * Disconnect negative battery cable * Detach the accelerator cable from the cable guides on the valve cover (It's not necessary to remove the cable guides unless you're replacing the valve cover) * Disconnect the PCV and breather hoses from the valve cover * Remove the spark plug wire cover bolts remove the cover and then remove the spark plug wires * Remove the bolts that attach the upper timing belt cover to the valve cover * Remove the valve cover bolts and then remove the valve cover


What should be removed first before removing top cover?

remove guy ropes


Can you peal carrots the night before?

Sure you can peel them ahead of time. Just make sure you cover them with water and refrigerated and used within a day.


Is it smart to remove a phone's battery cover before charging?

No, it does nothing more to help at all.


How do you remove the valve cover on a third generation Accord?

On carbureated models you will have to remove the air cleaner assembly. remove the ground cable from the fron of the cover. Remove the 3 nuts from the top of the valve cover. carefully remove the washer/grommet assemblies. To reinstall: Clean the rubber grommets and check the valve gasket before reinstallation tighten nuts to 7ft. lbs.


How do you tighten the side mirror on 1994 Chevy silverado pickup truck.?

Before you try to remove the plastic cover, there is a small screw that you have to remove at the bottom of the cover. When you get the cover off, there are two small bolts. The top one was the one that was loose on mine.


How do you remove the valve cover on a 1998 suburban?

To remove a valve cover on a 1998 Suburban, you need to take all of the valve cover bolts out. Lift the cover slightly, then see what is in the way of sliding it out (hoses, fuel rail, etc..) Remove and items blocking the removal then lift the cover off. Make sure to clean the cover and head of all old gasket material before installing a new gasket and bolting the cover back on.


What is the Oven temperature and Cooking time for Zatarain?

Keep frozen. Ready to cook. Microwaveable. Do not thaw. Keep frozen until ready to use. Due to variations in all ovens, cooking times and/or temperature may require adjustment. Internal temperature of product should be 160 degrees F when done.Microwave Cooking:Remove bowl from carton. Cut a slit in center of film.Microwave on High for 3 minutes.Carefully pull back film and stir (Note: Center may still be frozen). Re-cover and continue cooking on High for 3 minutes.Carefully remove film, let stand for 1 minute and stir before serving.Conventional Cooking (Dish cannot be used in broilers or toaster ovens):Do not preheat oven. Remove bowl from carton. Do not remove or pierce film.Place bowl on cookie sheet and place on center oven rack. Cook at 350 degrees F for 50 minutes.Carefully pull back film and stir. Replace film and continue cooking for 5 to 10 minutes.Carefully remove film, let stand for 1 minute and stir before serving.


Is yogurt cover pretzels a good source of calcium?

No, yogurt covered pretzels are not a particularly good source of calcium. The the candy coating has far more sugar in it than it has any yogurt or other dairy product.


Where is the starter located on the 2003 Honda Element?

There is a plastic cover in front of the engine. Under the cover is the intake manifold. After you have removed the plastic cover, then the intake manifold you will see the starter. Before you can remove the starter you will need to remove wires tubes and linkages. It will take a few hours if you are good.