Want this question answered?
5-6x150 Cu. BUS BAR PER PHASE
...because it is an infinite bus bar, meaning it can supply infinite current. By Ohm's law, since the voltage at the bus bar is fixed, to have infinite current, you must have a zero impedance.
The Bus Bar is (usually 3, or 4) solid copper bars that run through an MCC (Motor Control Center) and just supply power to the individual 'buckets' (compartments that contain the individual motor starters). The only protection for a bus bar would be from the 'Panelboard', or 'Switchboard' breaker that feeds the bus bar mounted in a separate MCC. Make Sense???, let me know if not...
To avoid accumulation of moisture.
Busbar Length x Busbar Size x 0.009 ex- Length= 12meter Size = 60 X 10 mm ie, 12 x 60 x 10 x 0.009 Ans = 65 kg Can you please let us know what is "0.009" for??? Ans: 0.009 = copper density Max. Current for 60 x 10mm = 60 x 10 x 1.55 = 930 AMP What is "1.55" for??
1162.5 amps
The following sizes of bus-bar will have the capacity to handle 1000 amps, 3/16 x 4", 1/4 x 3 1/2", 3/8 x 2 1/2", and 1/2 x 2".
To obtain the amp of the copper bus bar, multiply the width of the bus bar by the thickness of the bus bar to obtain the current carrying capacity of the bus bar.
Cross section area =60x10=600Sqmm For copper we can utilised 2 amps per sqmm hence we can load upto 1200 amps easily.
negatively charged
5-6x150 Cu. BUS BAR PER PHASE
Single bus is used in smaller, less important substations. A fault on the bus requires tripping of all lines into the bus. When higher redundancy is necessary, ring and breaker and 1/2 schemes are used. These are the three most common.
The term "bus bar" refers to a strip of bar of brass, aluminum, or copper. This strip of bar conducts electricity with a distribution and switch board.
Bus bar is a physical component that carries the current. AMP is unit of current. They can not be converted
...because it is an infinite bus bar, meaning it can supply infinite current. By Ohm's law, since the voltage at the bus bar is fixed, to have infinite current, you must have a zero impedance.
Bus bars are actually simple conductor strips of copper using for connection between one system to another.for example transformer to panel. bus ducts are enclouser of that bus bar
voltage of incoming machine should be same as that of bus bar voltage