Not all do I would hope. It's something wrong with your gears most likely.
5.7 quarts for automatic transmission
To check the hold light blinking of a Mazda Protege, take off the plastic over the shifter tube or bar. Then take off the console below it and look at the wires that come up from the hollow center of the tube. The edge of the shifter tube may have cut through the wire insulation.
Take off the plastic cupholder fairing that surrounds the shifter; it's under the deck and AC controls.
where is the thermostat on a 1999 mazda protege?
Were is the egr on a 1992 mazda protege
The nylon bushing at the bottom of the shifter is worn out. remove console. put shifter in the neutral position, unbolt shifter from transmission. replace bushing, then reinstall. good luck...
Where is the headlight relay in 1992 Mazda Protege?"
Where is the thermostat location on mazda protege 2003?
Where is the igniyion coil on a2002 mazda protege
not likely. the 1997 Mazda protege is a different chassis than the 1999 protege (BHA to BJ, respectively). the two transmissions between the two generations are also different, the BHA utilizing the FB4A-EL automatic transmission and the BJ utilizing the FN4A-EL automatic transmission. they also have different engines. you're better off going to a junkyard and pulling a auto trans from a third generation protege (1999-2003)...that would work. if you have any further questions, you can follow this link: www.protegefaq.net hope this helps!
Bent shift linkage or you are parking on a hill.
Yes the 1994 Mazda Protege is a OBD 1 port