the two most common no start when hot causes are fuel pump in your fuel tank and loss of spark ignition module
when the engine is hot the check engine light came on and the fan(is ok) don't start
There is a large screw which goes through the coil pack into the engine block. That screw will get to hot and then cause the engine to stop or not start back when it's hot.
it should start at cold
Yes the reason for that is because the engine is over heated and when its cold the engine is nice and cold perfect for starting conditions.
Because the engine gets too hot. Let it cool down before you start it up again. Poor water on it.
engine coolent temperature sensor is giving incorrect readings when warm
It is bleeding down---- Leaking fuel out of the fuel bowl and flooding the engine. In other words fowling the spark plugs out. When a engine is cold it needs more fuel to start. But when a engine is hot it needs less fuel to start. You need to make sure the choke plate is opening all the way up when engine is hot and it should stay open until engine cools off. If it is closed when engine is hot that will also flood the engine and it will not start. If choke is working then REBUILD carburetor.
If there is no check engine light illuminated, start with the basics like a good tune up.
Very literally, hot wire is a wire that is hot. Pertaining to vehicles, to hot wire a vehicle is to start the engine or motor of the vehicles without the use of the ignition.
probably needs the TDC Sensor cleaning.
Try replacing the engine coolant temp sensor.
Try putting the pedal to the floor while cranking it