It doesn't necessarily need and IP. Depends on whether it is a managed or unmanaged switch. For instance your switch would need an IP address in order to telnet to it.
A layer 2 switch may need an IP address if the operator wishes to be able to access it without a serial cable. With an IP address, the switch can be access from anywhere with a connection to the network or an Internet connection.
You can't assign an ip to a switch but you can add one to the interfaces......... like: for the management vlan (or any other vlan) Switch(config)#int vlan 1 Switch(config-if)#ip address {your ip address} {mask} Switch(config-if)#no shutdown any other port Switch(config)#int <fa, G, S> <interface number i.e. 0/0> Switch(config-if)#ip address {your ip address} {mask} Switch(config-if)#no shutdown and for a default gateway Switch#conf t Switch(config)#ip default-gateway {ip address}
No, even though the two PCs are physically connected they need an IP address to communicate. The switch uses the MAC physical address to determine the switching but the network software requires an IP address and a subnet mask attached to the adaptor.
Basically, any device that needs to communicate with another device on an IP network will require an IP address. so, each PC and router will need an address, along with anything else per above: a switch, a server, and IP phone, etc.
ip address need in bsnl
yes switch work on ip address.
The Cisco switches I have seen don't have an IP address by default. You have to connect to the switch with a console cable - one that connects to the console port on the switch, and to the serial port on the computer - and do some initial configuration, including the IP address.The Cisco switches I have seen don't have an IP address by default. You have to connect to the switch with a console cable - one that connects to the console port on the switch, and to the serial port on the computer - and do some initial configuration, including the IP address.The Cisco switches I have seen don't have an IP address by default. You have to connect to the switch with a console cable - one that connects to the console port on the switch, and to the serial port on the computer - and do some initial configuration, including the IP address.The Cisco switches I have seen don't have an IP address by default. You have to connect to the switch with a console cable - one that connects to the console port on the switch, and to the serial port on the computer - and do some initial configuration, including the IP address.
no you need an ip address
You can change your Gmail address after you change your IP. You however do not need to do that. It is because gmail is independent of IP address.
The current IP Address is: "69.12.3.35"I don't know why you would need it.
A "host" is simply any point that has an IP address. Typically a computer, but it may also be a printer, a switch, a router port.A "host IP number" is an IP number that can be assigned to a host. This excludes the first and last IP address of each network, which can't be assigned to hosts.A "host" is simply any point that has an IP address. Typically a computer, but it may also be a printer, a switch, a router port.A "host IP number" is an IP number that can be assigned to a host. This excludes the first and last IP address of each network, which can't be assigned to hosts.A "host" is simply any point that has an IP address. Typically a computer, but it may also be a printer, a switch, a router port.A "host IP number" is an IP number that can be assigned to a host. This excludes the first and last IP address of each network, which can't be assigned to hosts.A "host" is simply any point that has an IP address. Typically a computer, but it may also be a printer, a switch, a router port.A "host IP number" is an IP number that can be assigned to a host. This excludes the first and last IP address of each network, which can't be assigned to hosts.
A private IP is for internal networks, a public one is for a WAN or the Internet.