0
How do you remove wrinkles from the bottom of an in-ground pool and why are they there if the pool is new?
Hydrostatic pressure or poor water chemistry. If the watertable is high the liner will float and when the water recedes will create a suction and pinch the liner. If your alkalinity and stabilizer levels are low the sanitizer will not have any molecules to attach to so it goes after the vinyl. The pulls the plastizer out the vinyl and causes it to prematurely fade and wrinkle.
What else can I help you with?
How do you remove wrinkles from the bottom of an in ground pool and why are they there if the pool is new?
The wrinkles are there to provide for liner shrinkage over the years.
Is it possible to change a concrete pool into a liner pool if your inground concrete pool has cracks along the side down near the bottom?
Yes it can be done
Does Justin Bieber have a inground pool or a above ground pool?
Justin Bieber has a inground pool
Footprints on bottom of inground pool liner?
I had an inground pool installed. We just turned on the lights at night and noticed footprints on the bottom. Can this be fixed? Call the pool company back. The bottom is normally sand mixed with cement. The liner will probably have to be removed and bottom smoothed. They should have checked that before installing the liner. Those printswi catch sediment and debris for the life of the liner.
If an inground vinyl liner gaps from the wall at about the water line and wrinkles on the stairs is your pool contractor correct when he says it will tighten on its own?
If your pool has been filled with water, The wrinkles will not come out. And I do not understand the other part of the question.could you be more specific it does not sound correct that there be a gap at waterline.
Is it wrong to drain your plaster pool when the temperature is above 100?
Why would you drain your pool just becasue the water is hot? Never drain your inground pool unless you have first cut holes in the bottom of the pool to keep it from floating. If the water table in your area is high enough, your inground pool could "float" out of the ground, effectively ruining your pool.
How do you clean the walls of an inground cement pool that have become chalky?
A light acid wash should remove the chalk.
How many gallons of water in the star dust inground swimming pool?
How big is the star dust inground swimming pool.
Has anyone ever used sani-tred products in an inground pool with steel sides and vermiculite bottom?
Vermiculite is not a suitable substrate.
How do you remove last bit of water from inground swimming pool?
To remove the last bit of water from an inground swimming pool, you can use a submersible pump or a wet/dry vacuum. Place the pump at the deepest point of the pool to efficiently drain the remaining water. If you’re using a vacuum, insert the hose into the pool and set it to the appropriate setting to suck out the water. Additionally, you can tilt the pool slightly or use a siphon method with a hose to help remove any remaining water.
How do you scrub the bottom of an 8 ft inground pool when it is very difficult to push the pole down that far?
You need a pool tele pole that is 8' and extends to 15' k
How do you tell by looking at above ground pool pumps verses inground pool pumps if they will work for my inground pool?
They will most likely work, they just have to have the same specifications.
