0
If you had your brakes worked on recently you need to have them bled. If not then you have a leak somewhere. Try listening to the master cylynder or the ABS resivoir and see if you can hear air coming from them. If not try bleeding your brakes and see if that helps.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do I start a car?
Safest way: Set Parking brake Push clutch pedal to the floor Shift to neutral Turn key to start
How do I Start a standard car?
Safest way: Set Parking brake Push clutch pedal to the floor Shift to neutral Turn key to start
How do you reset the oil change light on a 2011 grand caravan?
Key on, engine off. (if push button start, press button twice without touching brake) press gas pedal to the floor three times.Key on, engine off. (if push button start, press button twice without touching brake) press gas pedal to the floor three times.
How do you I start my Honda elite 150?
put bike on stand turn key to on position press and hold brake pedal on floor bored press start button
When we bleed the brakes with the car turned off turned off the brakes seem good As soon as you start the car and the power assist kicks in the brake pedal goes right to the floor Help?
Brake Pedal Goes to the Floor After BleedingAlthough there could be more than one reason, I suspect that even though you may have bled the brake system, AND the brake fluid reservoir is full, your brake bleeding was not successful, and you STILL HAVE AIR IN THE BRAKE LINES, or in the wheel brake slave cylinders.
What does it mean when you depress brake pedal your lights go dim each time?
depress the brake pedal and turn the engine switch to the start posiiton and start the engine,,, Does this mean to hold the brake down until you hear the engine start.
How do you know when the Master Cylinder is going out?
Start the engine. Place you foot on the brake pedal, and press fairly hard and hold the pedal down. If the pedal very slowly, moves toward the floor any at all, the master cylinder is defective. Replace it immediately!!!!!
I have a 2001 Isuzu Rodeo LS with an Automatic transmission. I put the key in and it won't start and the floor shift won't move at all. What could be the problem?
Push down the brake pedal then try to start it.
How do you you know if a brake booster is bad?
Start the engine and then push the brake pedal down. If it is soft and easy to push then the booster is okay. If booster is BAD the brake pedal would be hard to push.
How do I know when to check my cars brakes?
The best way to know when your automobile needs brakes is when they start squeaking, grinding against metal, leaking brake fluid and the pedal going to the floor.
What are symptoms of a bad power brake booster?
hard brake pedal is the most obvious sign only way i know to test a booster, is to turn engine off. use brakes several times till pedal is hard. then with brake applied,start engine. the brake pedal should then soften.if the pedal stays hard the booster is bad
On a 1999 Ford Taurus what causes the brake pedal to all the sudden lose all pressure or resistance and start going almost all the way to the floor to stop the vehicle with the dash brake light on?
Defective master cylinder. Replace it ASAP
