Want this question answered?
Short communication line to ground (with ignition off) and try to start the engine. It should be impossible because PCM is not getting the VTSS message from the BCM. Remove short from line and turn ignition on. With ignition on short communication line again. Done.
it could of been a short in the wiring in the engine compartment or you had a fuel leak and it got into wires or the ignition system
I would pop the hood when the car is running and see where the smoke is coming from. My bet is oil or coolant leaking onto the exhaust manifold
Short answer Yes. Petrol is useful for running a engine, and extremely dangerous if misused.
Sounds lean.
This guage is to register the RPM's (revolutions per minute) the engine is running. In short, how much the engine is revved up.
I hope you did not remove a battery post while the engine was running (don't do it)? If so, it may cause damage to your alternator, and it will short out your ignition in the engine (engine stops). If there is no damage, it should work after reconnecting the battery posts. If you didn't do the above situation, I would check for a loose connection on the terminal or a corroded/broken cable. I hope you did not remove a cable from the positive or negative battery posts while the engine was running (don't do it)? If so, it may cause damage to your alternator, and it will short out your ignition in the engine (engine stops). If there is no damage, it should work after reconnecting the battery posts. If you didn't do the above situation, I would check for a loose connection on the terminal or a corroded/broken cable. THe computer may need alittle time to relearn idle.
The word "ignition" has a short vowel sound.
That would be short for "generator" light. If that light is on while the engine is running, the charging system is not working and you are running off of battery power only.
no, meryl steep does not have a disabled child but her child is short-sighted
That would be short for "generator" light. If that light is on while the engine is running, the charging system is not working and you are running off of battery power only.
You don't. You change the ignition switch.