0
Why does low coolant level message come on in a2002monte Carlo ss when radiator is full?
Wiki User
∙ 8y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the low coolant sensor on a 2002 Monte Carlo?
On a 2001 Monte Carlo it is located on the radiator just below the radiator cap.
Coolant drain 2003 Monte Carlo?
It is on the bottom of the radiator just below the lower radiator hose.
What is the correct coolant level for a 1999 Monte Carlo?
Radiator full and coolant recovery tank filled to mark Radiator full and coolant recovery tank filled to mark
Where is the coolant drain on a 95 Monte Carlo?
Look at the bottom or rear of radiator
Where is the coolant drain on a 1985 Monte Carlo ss?
look on the bottom corner of the radiator, either on drivers side or passenger side.
Where is the coolant and oxygen sensor on a 2000 Monte Carlo SS located and how do you change it?
the coolant sensor is in the radiator on the passanger side the oxygen sensor is in the exhaust system on the manifold and the pipes and sometimes both
What caused the 1997 Monte Carlo to run hot?
many possible causes, low coolant, worn out coolant, bad thermostat, no circulation (water pump) radiator blockage, pressure loss somewhere
1998 Chevy Monte Carlo as of lately the low coolant light will come on and there is antifreeze in radiator and the resevoire has up to the line what can the problem be?
did u bleed the coolant system of air cuz that could be the reason
How do you change radiator in Monte Carlo ss 2001?
how to change a radiator in 2001 Monte Carlo
Where is the low coolant sensor located on a 2001 Chevy Monte Carlo?
should be mounted on the radiator side either front or back and has a plug held in by a clip.
Where is low coolant sensor located on 1999 Chevy Monte Carlo 3100?
Look on passenger side of radiator about 6 inches down on the side its right there.
Why won't my coolant light go off on my 2002 Monte Carlo?
Did you change the radiator? If you did you might have the wrong one,without a full provission for the sensor. If you did not the plug might be disconnected or faulty.
