answersLogoWhite

0


Best Answer

Change the plugs and plug-wires. DON'T gap the plugs!! Outta the box and into the engine, ONLY!!

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does mt 2000 ford focus run rich and want to stall?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why would a ford contour stall while going around a corner?

i had this happen before. it was before i cleaned out the lower intake manifold. car was running too rich and not getting enough air. when i turned the steering it would put stress on the engine when idling and then stall.


What has the author Rich Fettke written?

Rich Fettke has written: 'Focus'


What the DTC code P2195 mean on an 2003 Ford Explorer?

P2195 - stall at idle after a cold start P2195 - front HO2S signal stuck lean P2195 - may be displayed in case of " stuck rich "


Is Henry Ford poor or rich?

Dead. But he was rich...


When did Rich Dimler die?

Rich Dimler died in 2000.


When did Martin Rich die?

Martin Rich died in 2000.


How rich was Henry ford?

gau


What does code p1451 mean on your 2000 ford explorer?

This means the vacuum control solenoid for the EVAP is not working and needs to be checked.


Ford Focus 2.0L SOHC broke timing belt Replaced belt now runs very rich Why?

The 2.0 SOHC is a NON- Interference engine, make sure you have your your marks aligned, sounds like you are off a tooth


When was Rich Dad Poor Dad created?

Rich Dad Poor Dad was created in 2000.


When was The Playa Rich Project created?

The Playa Rich Project was created on 2000-11-14.


When its really hot out or i turn my 96 ford explorer on and off too many times it will stall or it will start but seem like its not turning over all the way then when stopped will stall out?

Normally this is caused by a system that is running too rich (too much gas) or the timing is way too far advanced; you should have a check engine light on and a trouble code that indicates where the problem may be. Be sure and bypass the computer control if you check the timing.