0
Why does my 3.8L 1986 Oldsmobile start and run just fine but will not fire up again after turning it off unless I wait several hours in between start-ups?
Wiki User
∙ 17y ago
It is not the Crankshaft Positioning Sensor, Idle adjustment sensor, Battery, wiring, ignition modules or plugs.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Why is my 95 Oldsmobile achieva turning off while I am driving?
Because it's old
Oldsmobile silhouette 2001 traction control comes on when turning?
Check your control arms. Bushings could be bad.
Where is the turning signal flasher fuse located on a 1997 Oldsmobile achieva?
leftof steering column behind i/p
Role of small business in The Society?
Small businesses today helps create jobs, as well as foster startups and ideas - turning them into the next big, innovative concept that can help the society become better.
Turning between centers on the lathe is known as?
plain turning
What battles were the turning points of the American Civil War?
there are several turning points but the main one is Gettysburg
Would a Cracked head keep a 99 Oldsmobile intrigue from turning over?
If by turning over you mean the starter spinning the engine, no. If the engine is locked up (try turning it clockwise by the crank bolt), then you've either thrown a rod or broken a timing chain.
When after a Bobcat mini excavator was turned on to its side engine smokes on startups white smoke and blue smoke which comes in stages then machine seems OK?
This usualy happens after turning just about any machine on its side but no worries it will be ok
What are the important changes to an amphibians metamorphosis?
The process of the larva turning into an adult frog or newt. There is a group of amphibians called axolotls that do not undergo metamorphose. Metamorphose cal last between several weeks and several years depending on the species.
What is the differences between milling and turning?
Basic difference between turning and milling is that , In turning the tool is fixed and the job rotates whereas in milling the job is fixed and the tool rotates
What is difference between turning machine and lathe machine?
There is no difference between a turning machine and a lathe. They are two names for the same kind of machine
Can Yaesu FT-60 be damage by turning it on and off?
I have owned several 60's and have done a lot of turning on and of with no problems whatsoever.... Roger
