One trace of the oscilloscope traces have to be inverted to display the voltage and current with the correct phase relationship because you are probably connecting to both sides of a small resistor in series with the load. The supply side shows voltage, while the load side shows voltage drop for the load. You are showing differential voltage across the resistor in the second trace and, of course, its negative.
If, however, you are using a current probe, perhaps a clamp-on ammeter, I would question if you have it connected correctly.
Oscilloscopes only measure voltage over time. Current cannot be measured with an Oscilloscope directly, but can be measured indirectly. Measure the voltage across a known load and calculate the current.
One is sinusoidal through the zero point i.e. alternating current, the other would be a flat line at whatever the current value was i.e. direct current
Correct electrode size Correct current Correct arc length Correct travel speed Correct electrode angle 💯
This is most easily done using an oscilloscope with a current probe. Also phase angle must be measured relative to something else, usually the AC voltage at one end or the other of the branch of the circuit where the current is being measured.
with the help of function generator we found wave in oscilloscope
A standard oscilloscope is designed to measure voltage, you need a current probe for your oscilloscope to measure current.
An oscilloscope is, essentially, a voltmeter -it measures current by measuring the voltage drop caused by that current across a standard resistance.
An analog oscilloscope.
Oscilloscopes only measure voltage over time. Current cannot be measured with an Oscilloscope directly, but can be measured indirectly. Measure the voltage across a known load and calculate the current.
The meaning of the word oscilloscope is a device used for viewing oscillations, electrical current or voltage or, with a display on the screen of a cathode-ray tube.
Use an Oscilloscope
An oscilloscope takes an electrical input signal and converts it into a visible trace on a screen - i.e. it converts electricity into light. An oscilloscope helps us to measure the voltage(maximum)....We can also find frequency from it by using a Equation.. We can use the maximum voltage in this equation i=v(maximum)sinѠt to find the current.
An oscilloscope is a device that views electrical current or other oscillations on a cathode ray tube screen. A compression wave, meanwhile, is a type of wave that forms rarefaction when it moves down a channel.
One is sinusoidal through the zero point i.e. alternating current, the other would be a flat line at whatever the current value was i.e. direct current
An oscilloscope is a device that measures oscillations, such as from current or voltage. For electric instruments, such as an electric guitar, this device can be important to help make sure that the instrument and its equipment are functioning properly before a concert.
Eng Nurudeen Abiola Frequency measurement voltage measurement current measurement phase angel measurement
IT DEPENDS WHAT MEASURING INSTRUMENT YOU ARE USING. RMS - IF USING THE CLAMP AMMETER OR PANEL METER OSCILLOSCOPE - BOTH CAN BE READ