Want this question answered?
the use and consistency of the use
volts.
AA zinc and alkaline batteries normally provide 1.5 Volts when they are new. The voltage will drop as the battery discharges. Rechargeable batteries using NiCad or NiMH technology deliver 1.2 Volts when fully charged. Again, the voltage will drop as they discharge. It is this small voltage difference that can make rechargeable batteries less effective for some voltage sensitive applications,
110 volts was chosen to make light bulbs practical and economically competitive with gas lighting. Edison selected 100 volts as a compromise between distribution costs and lamp costs. Generation was maintained at 110 volts to allow for a voltage drop between generator and lamp.[1]
A resistor in parallel with a voltages source will not cause the voltage to drop, theoretically. To get a 20 volt drop you need a resistance in series, and the number of ohms is 20 divided by the current in amps. If the current is unknown or variable, the voltage can't be dropped by using a resistor.
This is normally caused by higher and lower demands on the electric grid. Voltage measured at a receptacle can vary as much as 10 volts during the day. a drop from 118 to 112 is perfectly normal and will not harm standard household appliances.
Information is inadequate to answer the question
the use and consistency of the use
volts.
forward bias 0 volts, reverse bias infinity volts.
The voltage drop across an LED varies, but is typically around 2 volts.
6 AWG will handle 50 amps with a voltage drop of about 4 volts. If you go to 4 AWG and limit to 50 amps your voltage drop will be 2.5 volts.
the answer is dc volts are rectified from ac volts and the amperage will be the same unless you account for the slight drop from the rectifier. dc volts from a battery have no relationship to ac volts. you can derive ac volts from a dc source using an inverter.
The neutral and earth are connected at the supply transformer, so 13 volts on the neutral means that you are far enough from the transformer to have a 13 volt drop on the neutral. You probably have the same drop on the live, so the total volt drop could be 26 volts, which may be excessive. It could indicate a fault somewhere.
What is the voltage drop running through resistor one
It is generally accepted to be approximately .7 volts.
12 volts