as the air dissipates, therefore the cream goes back to liquid form rather than remain aerated
Wasp spray. They drop like flies in a few minutes.
no it just keeps them away from u or just for a few minutes
Below freezing point. After a few minutes, it will turn to milk.
Not that i know of but you could use a massive force of positive energy to melt the iron in a few seconds.
it can drop off after a few minutes, and it can drop off after a few days, sooner or later it will drop off by it self, and you MUSTN'T treat the wound after it
To thaw ice cream quickly and safely, place the container in the refrigerator for about 30 minutes or run it under lukewarm water for a few minutes. Avoid using hot water or the microwave to prevent melting or damaging the ice cream.
yes it will hurt for a few minutes but then you get ice cream yum yum so its good
The usual doses include:1 Spray of Nitrostat spray - repeated every few minutes as needed. 0.4 mg tablet under the tongue - repeated every few minutes. 1 inch of nitropaste An IV drip of 5 mcg/ min titreated up to a max of 20 mcg / min
Believe it or not, Pledge furniture polish! Spray on, leave for a few minutes, and then wipe or scrub. It may take a few applications if there is a lot of buildup.
To effectively clean mold and algae from your house siding in just five minutes, mix equal parts water and white vinegar in a spray bottle. Spray the solution onto the affected areas and let it sit for a few minutes. Then, scrub the siding with a brush or sponge and rinse with water. Repeat if necessary.
Tanning spray is a widely available cosmetic product. Appropriately, there are no commercially available brands of tanning spray that do not wash out after a few showers.
To unclog the spray nozzle on a Pam spray can, first remove the cap and check for any visible blockages. You can soak the nozzle in warm, soapy water for a few minutes, then rinse it thoroughly and blow through it to clear any residue. If that doesn't work, try using a pin or needle to gently puncture any blockage. Finally, reattach the nozzle and test the spray function.