usually a bad wheel sensor, get it checked out.
The 1996 Chevrolet Camaro parking brake has an adjustment bolt on the parking brake. Turn the adjustment bolt to adjust the brake.
It is on the intake manifold near the thermostat.
You will have to remove the lens either the front or rear. you did not say which.
On multi-lever/turnsignal lever.
To reset the security light on a 1996 Camaro RS, first ensure that you have the correct key for the vehicle. Insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the security light turns off, then turn the key back to the "Off" position. Finally, turn the key back to "On" and start the engine; the security system should be reset.
Normally between 232 degrees to 235 degrees.
The 1992 Chevrolet Camaro turn signal flasher unit can be found beneath the drivers side dashboard. The turn signal flasher unit will be above the gas pedal.
No, its a bad earth somewhere
To reset the check engine light on a 1996 Chevy Camaro Z28, you can use an OBD-II scanner to clear the diagnostic trouble codes (DTCs). Alternatively, you can disconnect the negative battery terminal for about 15 minutes, which will reset the vehicle's computer and turn off the light. However, ensure that any underlying issues are addressed before resetting the light to avoid further complications. After reconnecting the battery or using the scanner, the light should turn off if no active issues remain.
Pull turn signal lever?
smash it with an axe as fast as you can
If it is not on the fuse panel then it is on the back of the dash near the steering column.